I've been reading this site for a few weeks and can't thank you all enough for the wealth of information I've learned so far! Here's the issue:
Bought a really cheap boat with a 40hp big twin a few months ago and it has been awesome! First trip out we limited on Kokanee and I've consistently out fished boats that I have less than 1% into my boat than they do. After about 8 trips using my bucket behind the boat to slow me down my motor quit running unless fully choked. First thought was plugs since it's always at close to idle. Wasn't the issue an motor sounded like it was sucking air. I've put all new fuel lines (both were cracked) new pump on, and cleaned entire bottom end of carb. No luck! Good thing I figured out how to make choke overide springs out of key rings and swivels or me and my 7 yr old would still be out on the lake. Checked compression on both cylinders and each are over 100 (from what I can tell as it was a shotty tool that didn't like to work). Checked spark today to make sure it wasn't electrical and bot shot a bright blue spark at well over 1/4" (my tester doesn't show inches but based on my measurements close to 3/8"). So based on what I've read here and other places I ordered a complete carb kit as there are some areas I think might be leaking fuel/oil. I pulled the starter to get the entire carb off tonight and the gasket to the motor was in less than great shape. The bottom end all looks new and like it's been done in last few years as it (including hi speed jet) is in pristine shape. So, hypothetically, this kit a a complete cleaning doesn't work, what else could cause this? It ran great for the first 7 trips out but now I'm spending my time at the motor while my 7 year old is either catching the fish or diving us back to the dock. So confused and very little 2 stroke experience so this has been a very frustrating learning experience. I have so little money into it that I want to finish it out but at some point I need to quit! Any thoughts on what else in could be?
Bought a really cheap boat with a 40hp big twin a few months ago and it has been awesome! First trip out we limited on Kokanee and I've consistently out fished boats that I have less than 1% into my boat than they do. After about 8 trips using my bucket behind the boat to slow me down my motor quit running unless fully choked. First thought was plugs since it's always at close to idle. Wasn't the issue an motor sounded like it was sucking air. I've put all new fuel lines (both were cracked) new pump on, and cleaned entire bottom end of carb. No luck! Good thing I figured out how to make choke overide springs out of key rings and swivels or me and my 7 yr old would still be out on the lake. Checked compression on both cylinders and each are over 100 (from what I can tell as it was a shotty tool that didn't like to work). Checked spark today to make sure it wasn't electrical and bot shot a bright blue spark at well over 1/4" (my tester doesn't show inches but based on my measurements close to 3/8"). So based on what I've read here and other places I ordered a complete carb kit as there are some areas I think might be leaking fuel/oil. I pulled the starter to get the entire carb off tonight and the gasket to the motor was in less than great shape. The bottom end all looks new and like it's been done in last few years as it (including hi speed jet) is in pristine shape. So, hypothetically, this kit a a complete cleaning doesn't work, what else could cause this? It ran great for the first 7 trips out but now I'm spending my time at the motor while my 7 year old is either catching the fish or diving us back to the dock. So confused and very little 2 stroke experience so this has been a very frustrating learning experience. I have so little money into it that I want to finish it out but at some point I need to quit! Any thoughts on what else in could be?