1965 Johnson Super Sea-Horse 40 no neutral or reverse

Harleydad

Recruit
Thread starter
Joined
Jun 23, 2018
Messages
1
Just got my 1965 SSH 40 on the water for the first time since I bought it last summer. Runs out pretty nice. However, I can not get it into neutral or reverse. The cable broke when trying, so I know it’s not that since I tried shifting it manually right on the motor. I pulled off the cover and the linkage (detents) near the powerhead moves, but can’t see anything further than that. Any thoughts? Do I have to disassemble the lower unit? Really hoping not. Looks like a ***** to get back together.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Are you saying the gear shift lever on the starboard side of the engine moves but the motor remains in forward? Well the shift rod is a two piece item, joined together in the midsection of the engine. There is a rectangular cover/hatch with two blade screws in opposite corners. Behind it is another cover/hatch that needs to be removed, then you can see the connector.
Here is a link for a slightly older version of the 40, but the stuff relevant to the shift linkage and gear case is the same
http://www.fiberglassics.com/library/images/a/a7/Evinrudeservice002.pdf

Page 57 shows the covers I mention # 18 and # 33.
Page 55 shows the Lower unit, but upside down for some reason #5 is the connector t join upper and lower shift rods that I referred to
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Working on those manual shift units is simple I think.-----No special tools / shimming required.-----Just careful work.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Inspect the shift rod connector as jimmbo outlined. That most likely is where the problem is. BUT, if the upper shift rod is not moving, it has broken or come apart inside, under the powerhead. That turns into a much more complex operation. It is possible the problem is in the lower unit, but very unlikely.

Does the water pump work? If it does, the drive shaft is rotating (that's good).
 
Top