1964 JW-19M 3hp Johnson carb problems

Valckyard

Recruit
Thread starter
Joined
Sep 12, 2017
Messages
1
Hi it is my first time posting on something like this.


Thanks to everyone that will take time to help me.

I cleaned everything and tried it. It started and went soso on choke no way to remove it it would speed up and run out of fuel. So i tried ajusting the float higher. That looked promising but ended up gaving too much fuel.

So i tried to give it a little more space now the whole engine wont go i have absolutly no clue what to do at this point. I looked at carb adjustment over the internet and all i end up seeing is the slow speed needle. Well its the only external setting other than the choke but it does not help me much.

Thx everyone

Alex Caron
 

valvebounce

Petty Officer 2nd Class
Joined
Mar 18, 2014
Messages
102
Sounds like a gummed up carb.Strip it and blow all the jets and orifices out with carb cleaner.
With the carb bowl off,turn the carb upside down,the float should be parallel with the carb body.It can be adjusted by gently bending the tab on the float near the swivel pin.The jets are very fine on a small motor and soon partially block.I don't think you have much of a problem,just a gummed up carb.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Is the high speed jet that screws into the bottom of the float bowl clean?---Is the filter in the gas tank clean ?
 
Top