1964 Evinrude 40 hp big twin - help!

igothefunk1224

Cadet
Thread starter
Joined
Mar 3, 2013
Messages
8
So I picked this beast up the other day. Compression checked out and lower unit oil checked out so I brought it home for a fair price. Tossed it in a barrel, started and ran fine, not spitting water. After pulling it out of the barrel I saw this crap leaking! I drained the lower unit oil and it seemed fine. Any ideas on what this is/causing this junk to leak out? Thanks for your time.
 

Attachments

  • IMG_20130517_003422.jpg
    IMG_20130517_003422.jpg
    148.9 KB · Views: 3
  • IMG_20130517_003430.jpg
    IMG_20130517_003430.jpg
    150.7 KB · Views: 3

kodibass

Master Chief Petty Officer
Joined
Apr 10, 2010
Messages
865
Re: 1964 Evinrude 40 hp big twin - help!

If you drained the lower unit oil and it looked fine, (black , tea colored or something close ) then I think you are fine.. If tan or creamed coffee colored..not fine. What I think you are looking at is emulsified exhaust oil, coming from a drain hole mixed in a barrel from a motor which has sat for a time. add new L/U oil go run it on a boat for a good long run. come back & check again...take a good fresh tank or two of 50-1 fuel mix......them big twin 40's love it!
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Re: 1964 Evinrude 40 hp big twin - help!

Perfectly normal. That is unburned fuel / oil mix that has gone through the motor, discharged into the exhaust stream, emulsified with the spent cooling water, and is now coming out the drain hole. Most of what you are seeing is because you had it running in a barrel, which concentrates all the crap. It will be better when running on a boat, and carburetor properly adjusted, but still expect some drainage. The oil that you put in the gas has to go somewhere. Some of it gets burned (smoke) and the rest goes out the exhaust. That's just the way it is.
 

igothefunk1224

Cadet
Thread starter
Joined
Mar 3, 2013
Messages
8
Re: 1964 Evinrude 40 hp big twin - help!

Thanks for the input guys. You mention a 50:1 ratio, the motor itself says 24:1? Do the new oil's allow it to run that lean or am I best sticking to the 24:1?
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Re: 1964 Evinrude 40 hp big twin - help!

1964 was the first year that Evinrude used 50:1. But that year they said only if you use Evinrude oil. The stuff you buy now is better than the original Evinrude oil by a long shot. Assuming it is certified TC-W3. If it is certified, it will bear the NMMA logo. Look out for the wannabes that say something like "meets TC-W3 requirements" but does not have the NMMA logo.
 

igothefunk1224

Cadet
Thread starter
Joined
Mar 3, 2013
Messages
8
Re: 1964 Evinrude 40 hp big twin - help!

Roger that. Thanks once again. I'm sure I will be bouncing a few more question's off you folk's again in the near future.:happy:
 
Top