1964 60hp evinrude

Doug Cordes

Recruit
Thread starter
Joined
Jul 7, 2015
Messages
4
I bought a 1964 60hp evinrude it has no controls, and I can't get it to fire. There is a black wire and a white wire coming from the coil I was wondering if I put the two wires together if that would make it fire or do I need one wire hooked to a battery or to a ground. I don't know a lot about these old boat motors. u guys on here know a lot about this. any help would be appreciated.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Your motor should have a Magneto Ignition if it is a 1964 engine. Here is a link to a service manual. It doesn't list the 60hp but the specs for the 50 are pretty much the same. Your engine will have a hot air choke, not a hot water choke in the manual and the 60 was rated at 4500 rpm with a full throttle rpm range of 4000 - 5000. Page 193 show wiring diagrams for the Magneto and Battery Ignition systems

http://www.fiberglassics.com/wiki/images/2/2a/Johnsonservice003.pdf
 
Top