1963 Evinrude Lark IV with e-shift jumping out of forward

Dick Diver

Recruit
Thread starter
Joined
Sep 7, 2016
Messages
4
I have gained some knowledge from this forum on the possible causes of this problem. I understand it is quite possibly a lower unit issue. I am considering taking on the work myself since I can't find anyone in the Buffalo, NY area to do it. I am reasonably mechanical and have worked on a number of mechanical problems but I have never worked on a outboard motor before. So I'm doing some research, I have the SELOC Johnson/Evinrude 1958-72 repair manual. Can you recommend any other sources for my education? Thanks
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
I have a tool to repair that problem.--------Usually no parts required.------Developed this tool 40 years ago.----------No longer do rush work for folks but occasionally visit the Hamilton , Ontario / Niagara area.----Have used lower units on hand too.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
I have gained some knowledge from this forum on the possible causes of this problem. I understand it is quite possibly a lower unit issue. I am considering taking on the work myself since I can't find anyone in the Buffalo, NY area to do it. I am reasonably mechanical and have worked on a number of mechanical problems but I have never worked on a outboard motor before. So I'm doing some research, I have the SELOC Johnson/Evinrude 1958-72 repair manual. Can you recommend any other sources for my education? Thanks

Very important--don't jump to conclusions. It is possible it isn't jumping out of gear at all. It could be the propeller hub slipping. Secondly, always check the electrical part before condemning the electric clutch. Especially the shift switch. They have a notorious failure rate.
 

Dick Diver

Recruit
Thread starter
Joined
Sep 7, 2016
Messages
4
Very important--don't jump to conclusions. It is possible it isn't jumping out of gear at all. It could be the propeller hub slipping. Secondly, always check the electrical part before condemning the electric clutch. Especially the shift switch. They have a notorious failure rate.


I have checked the switch, it seems to be OK. I changed the oil after it slipped and it was black and gritty. It ran fine for one outing and then returned to jumping and winding up. It looks like I have no choice but to drop the lower unit and inspect. any thoughts?.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
I would do a couple of oils changes first, make sure to use the correct oil in that gearcase. BRP Premium Blend. Type C was the initial oil speced, but as of late, there have been Oils claiming to be Type C but are not Electric Shift compatible.
 
Top