1963 5.5 Johnson lean rich screw.

1963 5.5 Johnson lean rich screw.

  • Missing cap pices

    Votes: 0 0.0%
  • Broke

    Votes: 0 0.0%

  • Total voters
    0

Lvolling

Recruit
Thread starter
Joined
Jul 12, 2016
Messages
3
First post here. I recently cleaned the carb on my 5.5, I have it running good now. I was putting everything back together except I can't get the plastic caps on my lean rich adjuster to adjust both needles, am I missing a pice between the two caps? I tried uploading pictures but no luck.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Well, pisces is a fish or an astrological sign. Think pices might be an acronym.

But those caps or knobs attach to the needles by tightening the little brass screws in the ends of the needles. Loosen to remove the knob. Set the knob in place where you want it and tighten the screw (brass -- don't overdo it).
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Should be a knob within a knob on that motor. Large (outer) knob remotely adjusts the slow speed needle via a connecting rod which goes up to a plastic valve arm. The inner knob connects directly to the high speed needle - it just pushes on the shaft.
 

Lvolling

Recruit
Thread starter
Joined
Jul 12, 2016
Messages
3
I have the wite knob on first then the orange knob, the vibrations of the engine running vibrates the white knob to rich. Shouldnt turning the knob adjust both the high a low speed needle?
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
My apologies, Lvolling. You can get a parts blow up of the carb and the marine engine site. The low speed and high speed needles remain separate. Each of the needles will have a gland nut at the carb body, and that is used to snug the needle in place -- want to adjust it sufficiently that it won't rattle loose, but not so tight that you can't adjust when operating. Good luck -- nice motor.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
I have the wite knob on first then the orange knob, the vibrations of the engine running vibrates the white knob to rich. Shouldnt turning the knob adjust both the high a low speed needle?
Tighten the packing nuts enough to hold them from spinning. And no, they adjust individually. There is a link between the large knob and slow speed needle.
 

Lvolling

Recruit
Thread starter
Joined
Jul 12, 2016
Messages
3
Ok thanks guys , I thought they adjuster together you just saved me alot off headache looking for the missing piece in the driveway that never existed, and now I can take the boat out saterday.
 
Top