1958 RDE-19C prop shaft end play?

Mr. Bradish

Recruit
Thread starter
Joined
Sep 30, 2012
Messages
5
I'm re-sealing the lower unit and found 0.022 inch end play on the prop shaft. This seems excessive because the tapered bearing moves out of the cone slightly.
What is right? What should I be seeing for in and out movement? Is this a matter of shimming or replacing parts?
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Some end play is normal. Can't say I've ever measured it though. If one of the thrust washers were missing, it would be a lot more than .022". Don't worry, the tapered bearing is held in place by the forward gear. The prop shaft moves back and forth between the forward and reverse gears (thrust washers), without moving the gears at all. Under power in forward gear, prop pushes on shaft, shaft pushes on thrust washer and forward gear, forward gear pushes on tapered bearing, bearing pushes on gearcase, and the whole schmear pushes the boat forward.
 
Top