1958 Johnson 35hp Super Sea Horse

Newton08

Cadet
Thread starter
Joined
May 30, 2017
Messages
7
In 1990 I replaced the entire electrical system on a 1958 Johnson 35hp Super Sea Horse that had been in storage for 14 years. It was properly adjusted and put in to the test tank. It ran like a clock and after about 5 minutes we let it run out of gas.
To shorten the story, I?ll just tell you that it hasn?t been started since. But this morning I rolled it out, dusted it off, took the plugs out and (don?t have a battery) pulled it through a few times: to my surprise, no spark!
Can you tell me, please, what the trouble is likely to be, and how do I fix it? Thank you.
 

82rude

Rear Admiral
Joined
May 8, 2012
Messages
4,082
Did you replace the coils back when?Ignition switch on?Been there done that,lol.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Lessee, 1990 to 2017==that's 27 years. Could be most anything. Yes, check to make sure the key is turned on. If not that, then you probably will have to pull the flywheel again. With luck, it might just be corroded breaker points' contacts.

You really ought to get out more, LOL
 

Newton08

Cadet
Thread starter
Joined
May 30, 2017
Messages
7
Gentlemen, I thank y'all (that's southern?I'm a transplanted Yank). I hope that the flywheel will come off easier this time.
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Remove the inspection port on top of the flywheel, and check the coils and points. You should be able to clean/adjust the points through the inspection port.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
27 yrs of sitting, it sounds like it wasn't fogged. I wonder what condition the bearings are in?
 

Newton08

Cadet
Thread starter
Joined
May 30, 2017
Messages
7
Captain: I am certainly glad to get the tip on the inspection port. From what little I've pulled on it, it seems ok. If I can get a spark I'll hook up a battery and give it a spin. Thanks much.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
27 years - likely the points are chalked up. Clean them with some 320 wet/dry then run a business card dipped in carb cleaner or lacquer thinner through them. Betchya you get spark back...
 

82rude

Rear Admiral
Joined
May 8, 2012
Messages
4,082
If i repeat if the coils are original no matter weather you get spark or not your on borrowed time.Ive actually crushed original coils from the 50,s with my hand.
 

Newton08

Cadet
Thread starter
Joined
May 30, 2017
Messages
7
Key on? Switch on? Duh . . . well . . . after trying most of your suggestions except pulling the wheel (don?t have a puller) and working with no remote controls, it finally dawned on me that about the first thing that you told me is that I need a closed ignition circuit! Duh . . well . . . will a jumper wire work? And which of all those terminals do I use? I should get a spark with each pull, right?
I?m sure that you can tell that I?m really sharp on this stuff, and, Gentlemen, I want to thank you all again for your help. More suggestions will be welcomed.
p.s. The coils and all electrical equipment was replaced in ?90, and has been used about five minutes
 

RCO

Petty Officer 1st Class
Joined
Jun 15, 2016
Messages
350
Ignition circuit is open to run on that motor. It will run with no wiring hooked up at all.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
^^True, as long as the kill circuit isn't closed. A keyswitch in the off position would close the circuit.
 

Newton08

Cadet
Thread starter
Joined
May 30, 2017
Messages
7
As Bobbie suggested on June 3, I pulled the flywheel?the local O?Reilly Auto Parts very graciously loaned me a hub-puller?and within an hour it was off; when I pulled it in 1990 it took three and a half days.
Everything was immaculately clean and bright, but I found that one magnet had no pull; should each be the same? Assuming that they should, and that this is probably the problem, can it be recharged? I hope.
Give me the dope, please. Thank you.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
???--There is only one magnet on that flywheel !!!-----One may look like a magnet but it is not.-----Clean the points !!
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Those magnets never lose their charge. Never.
 
Last edited:

Newton08

Cadet
Thread starter
Joined
May 30, 2017
Messages
7
Duh . . . well . . .yes, it looks like a magnet. I am very pleased to get such a prompt response, Sir, and I shall heed the advice of a? Supreme Mariner.? I will also use the ?Fleet Admiral?s? method of cleaning the points (I do know what they are) and I will let you know of the results of my labors. I thank each of you very much for your help.
 

Newton08

Cadet
Thread starter
Joined
May 30, 2017
Messages
7
Duh . . . well . . .yes, it does look like a magnet. I am very pleased to get such a prompt response and I shall heed the advice of a ?Supreme Mariner.? I will also use the ?Fleet Admiral?s? method of cleaning the points (I do know what they are) and I will let you know of the results of my labors. I thank each of you very much for your help.
 
Top