1957 evinrude fleetwin 7.5 hp not pumping water

DaltonPflughaupt

Recruit
Thread starter
Joined
Apr 17, 2016
Messages
2
Hello I have a 1957 evinrude fleetwin 7.5 horse that will not pump water I just replaced the impeller and still nothing I've cleaned it all out so there is no debris in the waterway but it will still not pump
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
First, run the leg deep enough (about half way up). If absolutely no water coming out of the port on the leg when you pull it over (certainly if dry when it fires), will need to pull the powerhead again and check the assembly. Impeller key in shaft, tube in the grommet. If you pull it apart again, I would test the l.u. in a tub of water before reassembly. Turning it by hand, should feel resistance from the impeller. It also works to spin it clockwise with a drill to test the pump operation.
 

DaltonPflughaupt

Recruit
Thread starter
Joined
Apr 17, 2016
Messages
2
I hooked it up to the drill and still nothing is there something else to replace down by the impeller?
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
You should have a pin inserted in the shaft to lock the impeller in place. Need to be able to feel the impeller turning with the shaft (turn the shaft clockwise by hand), or need to take off the housing to check assembly. If doing the latter, watch out for the loose pin laying on the wear plate.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
As noted above, the pump itself MUST be submerged to start the flow. The pump is not self-priming.
 
Top