1956 Johnson 30HP no spark after putting in all new electronics

bzktm8

Cadet
Thread starter
Joined
May 14, 2010
Messages
7
Hello,

I am a newbie to the forum but no stranger to engines of all types. This engine has me puzzled though. There is no spark after replacing both coils with ignition coil 18-5181, points and condensers and wires. I verified the coils are good on both the low and high sides. I also set the points to .020 and verified conductivity to the plug connectors. I still have no spark on either cylinder and ran out of ideas. The plugs are not brand new, but they fired before the new parts. I also converted to a 12v evectric starter which makes testing easier than the old rope.
Any suggestions would be appreciated.
 
Last edited:

Barnacle_Bill

Admiral
Joined
Feb 8, 2004
Messages
6,469
Re: 1956 Johnson 30HP no spark after putting in all new electronics

Re-check your points installation. If you are sure its correct try putting the old condenser back in. Its rare but new ones can be bad.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Re: 1956 Johnson 30HP no spark after putting in all new electronics

New points often have an invisible layer of non-conductive corrosion on them. Clean them shiny bright, make sure they are set at .020" at their widest opening, and re-test.

EDIT: I have to assume you have the coil wires connected to the right set of points, and the correct one grounded-----don't you?
 
Last edited:

bzktm8

Cadet
Thread starter
Joined
May 14, 2010
Messages
7
Re: 1956 Johnson 30HP no spark after putting in all new electronics

Well this is embarassing, I had the green wires criss crossed to the wrong set of points. They are correct now and re-checked the gaps. The point surfaces look like chrome they are so shiny. The top cylinder now has a nice blue spark now but the bottom still has no spark.
 

bzktm8

Cadet
Thread starter
Joined
May 14, 2010
Messages
7
Re: 1956 Johnson 30HP no spark after putting in all new electronics

I found the problem...putting it back together the way it was when I got it was the issue. The capacitors and green wires were on the insulated side of the points terminal. The screw head was shorting the circuit. I was really frustrated trying to get out the screws since the coil mounts were in the way. I looked at the picture I took before changing the parts and that was how the previous owner had it. No wonder he had problems. Thank you all for the advise.
 
Top