1950 Johnson seahorse 5hp no gas

Drummerking55

Cadet
Thread starter
Joined
Aug 14, 2017
Messages
8
I have a Johnson seahorse approx 1950. It has spark and the tank gets pressurized when I try to start it. Has gas to the carb and when I loosen any screw on the bottom gas comes out. But no gas is getting to the cylinders. When I spray a little starter fluid it fires no problem. Is there something I'm missing that is preventing the gas from getting into the cylinders.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
A 1950 5 hp would have the tank on top and be a gravity feed. Give us a model # or pic.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
The tank should be vented, not pressurized.

Check the carb float. Does the primer work when you push the knob downwards? Should make a very distinctive squish-squish sound when you do.
 

Drummerking55

Cadet
Thread starter
Joined
Aug 14, 2017
Messages
8
It does make a noise when I push it down but it seems that it does not move any fuel. The tank cap has a big cap and a center screw.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Check the screen in the tank. Center screw in the cap is the vent. TN 28 is a 52/53 model.
 

Drummerking55

Cadet
Thread starter
Joined
Aug 14, 2017
Messages
8
So a little more info. I took the carb off and hooked it up to the gas line only. With the top removed I watched it fill with gas and stop filling as the float rose. Then I tested the primer. As I pumped it gas came out the hole on the side of the carb that faces inward that the small copper tube attaches to. Put it all back together and still no fire. I must be missing something but I am not sure what.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Check for spark. Check the coils and points most of those motors need to have the coils replaced if they are original.
 

Drummerking55

Cadet
Thread starter
Joined
Aug 14, 2017
Messages
8
I checked spark. If I give it a little squirt of gas into the air inlet it starts right up and will run for 3 to 5 seconds
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Make sure the fuel line that is on the front of the motor is clean. Also make sure that needle is set correctly 1.5 turns out to start.
 

Drummerking55

Cadet
Thread starter
Joined
Aug 14, 2017
Messages
8
I have cleaned the tube that runs from the side of the carb to the front of the engine. Is this like the main jet or entrance for fuel. Does any fuel go through the air inlet. Sorry if these questions are noob questions but I'm use to working on motorcycles and this thing looks like it's in a whole different ballgame
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
That tube in front of the motor that goes to the Y shaped piece is the low speed circuit. When you pump the primer you should see a spray of gas through there.
 
Top