18hp 1964 evinrude overheating

Fullspeedahead

Cadet
Thread starter
Joined
Jun 6, 2016
Messages
20
I just put back together my 18hp evinrude after checking out the water pump and whatnot and am having some overheating issues....I took it out on the water and felt the thermostat housing and it was burning hot! I was took out the thermostat while I was on the water cause I thought it might have been faulty and started to take her to shore and the thermostat housing was still super hot! I thought by removing the thermostat would have made the engine cool down a little bit as I brought it to shore? Anyway I tested the thermostat and it opened but I bought a new one just in case it. I started her in a trash can and it still began to over heat. There was a small bit of the impeller missing but I checked all the passages on the head and didn't see anything...any thoughts or ideas of where to search for the missing piece of impeller? How deep do I have to pull this apart to find it or any other ideas ?
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Rig up a connector so you can connect a garden hose to the water tube. Take the thermostat out and leave the top off. Run the water and see if it's getting up to the thermostat housing. If it is, then I'd suspect your water pump is not pumping properly. I assume you installed a new impeller? Is the impeller drive pin in place? Is the water tube properly inserted into the grommet on the water pump housing?
 

Fullspeedahead

Cadet
Thread starter
Joined
Jun 6, 2016
Messages
20
Yea waters coming up I replaced the impeller and doubled checked it's in place with the drive pin. I think the passages are blocked so I just pulled the power head off to follow where the water goes to look for blocked passages. I'm trying to take off I guess would be the exhaust manifold but got a few screws frozen on there. Tried to used an impact driver you bang with a hammer but it's turning the bit....but hopefully I'll find a bunch of doo doo blocking a passage otherwise idk
 

texas_salt

Seaman Apprentice
Joined
Apr 7, 2016
Messages
42
Cant these older systems simply be pressurized? If so I would keep a bucket under the pee hole to see if u catch the culprit(s)

- 1969 6HP
 
Last edited:

Fullspeedahead

Cadet
Thread starter
Joined
Jun 6, 2016
Messages
20
Yea i ran a garden hose through where the thermostat sits in and tried to run it again and it still overheated...however there was some debris in the t stat after it closed when it cooled off. So I think there some other stuff: I've been reusing the same trash can filled with water that sits under a tree which turns out to not be a good idea
 

twocyclemania

Chief Petty Officer
Joined
Aug 10, 2010
Messages
505
My 83 Johnson 7.5 had an overheating problem. I would run it and eventually it would overheat for no apparent reason. Long story short; I found a piece of rubber (probably from the impeller) inside the exhaust housing ( under side plate). The rubber would act like a pinball in a pinball machine and eventually it would bounce around and plug the small hole where the water exits. Shut the motor off, it falls away and you're good to go until the next time. Took me a while to figure this one out. Just a suggestion!
 
Top