15hp 1996 evinrude with no spark

tschat

Cadet
Thread starter
Joined
Apr 1, 2018
Messages
6
Background: Motor was running before I started this repair. The compression was low, so I did a ring replacement. Now after putting everything back together, I have no spark. I have removed the power pack, cleaned up the ground wire and reinstalled, no change. Same for the ignition coil. I have also pulled the ground wire for the kill switch (bolts under the coil bottom screw) and no change. I understand that it could just be timing that something broke while working on it, but I am doubting this. Anything else to try? What steps can I take to identify which part is broken?
 

tschat

Cadet
Thread starter
Joined
Apr 1, 2018
Messages
6
Additional information. I found the CDIelectronics website. I have tested the stator and timer resistances are fine. I don't have a DVA to test the peak voltages. I am a little confused about testing the power pack since I don't have the blue or green wire they are referring to (unless they are talking about the actual spark plug wire).
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The orange / blue must go to the top coil.--------Sky is blue for the top.----Grass is green for the bottom.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
What was gap on the old rings.----What gap did you get with the new rings ?
 

tschat

Cadet
Thread starter
Joined
Apr 1, 2018
Messages
6
I am hoping that I forgot a ground wire or something in the reassembly, but I can't figure it out. Any ideas on how to debug the problem?
 

tschat

Cadet
Thread starter
Joined
Apr 1, 2018
Messages
6
Well, after removing the coil and power unit and sanding down the ground for the power unit, I have spark. Motor runs good.
 
Top