150 hp evinrude compression?

fuzzyrickt

Recruit
Thread starter
Joined
Aug 16, 2003
Messages
1
I've got a 150 hp evinrude 1989, whats the compression supposed to be. I had it checked and t is between 90 & 100 lbs. I need a new power pack ingnition because it is only firing on 3 cyl. It has been sitting only about 3 months and my mechanic is suggesting a complete overhaul of the powerhead. It has always been hard to start and I might have washed the cyls trying to start it with the bad powerpack. Any suggestions.....
 

Dhadley

Supreme Mariner
Joined
Feb 4, 2001
Messages
16,978
Re: 150 hp evinrude compression?

Welcome to the board!!<br /><br />The compression numbers depend on a number of things including which heads, which head gaskets, and different gauges. the numbers fall within the OMC spec of "no more than 15 lbs from high to low".<br /><br />I would suggest a decarb job and address the starting issues seperately. Sounds like a good motor.<br /><br />Good luck!
 

clanton

Rear Admiral
Joined
Jul 9, 2001
Messages
4,876
Re: 150 hp evinrude compression?

You need second opinon, on the overhaul. I agree with DH. This motor may have only had 100 psi when new.
 

The Marine Doctor

Commander
Joined
Jul 25, 2003
Messages
2,177
Re: 150 hp evinrude compression?

I have seen rebuilds with 90psi a cyl. Its misleading but its what they run with.<br /><br />TMD
 
Top