115 v4 2 stroke runs rough when warmed up

Jdepoy

Cadet
Joined
Sep 22, 2024
Messages
7
Hey guys, new to this forum and new to boating! I recently acquired a 94 four winns fling with johnson evinrude 115 engine. Im having some engine issues and I'm not sure where to look next. So the first time taking the boat out it performed great, planed oit quickly and nicely, git to about 38mph and had a blast, ran wot most of the time for about and hour and a half and then the boat died it started back up but wouldn't get up to wot without stumbling and dying again. After that i brought the boat back home and decided to do some maintenance on it. When it died it felt like fuel starvation so i rebuilt both carbs on it and threw a new fuel filter in it and spark plugs. It ran great at home idle fine, held wot fine. I put it in the water and it did the same thing as it did the first time just after about an hour, it ran fien at wot and them just suddenly boggs down and dies. Once it does this it gets hard to start and stay running im lucky if I get ¼ throttle out of it to get back to the ramp and even then it'll die sometimes. So I did have a small water leak from the adapter plate from the jet drive to the engine i figured that could be my problem it could be slowly heating up and getting to hot and loosing spark or something so I took the engine out and fixed the leak and took it back out and now it lasted about 15min up on plane at wot before it died and it seems this problem it just getting worse but it seemed fuel related so my grandfather had an old fuel cell from his old boat he let me use and I bypassed the vro and ran my own inline pump with regulator and mixed 50.1 in the tank. I took it out like that and only got maybe 5 minutes of wot before it bogged down and died. I'm pretty positive now it's not the fuel system it has to be spark related. Is there any way to test the power pack to see if it's getting hot and loosing power? Also side note of I'm in the water and put it in nuetral and rev it it usually has no issue revving up fine its mainly under load. And if I and moving at maybe 10mph and maybe ⅜ throttle it'll without touching anything it'll bogg down and them pick back up and then bogg down and pick back up. So I'm at a loss. Any diag help is appreciated!
 

racerone

Supreme Mariner
Joined
Dec 28, 2013
Messages
37,814
Some will argue.-----The first step in trouble shooting is a compression test.----Post the actual values.
 

Jdepoy

Cadet
Joined
Sep 22, 2024
Messages
7
Some will argue.-----The first step in trouble shooting is a compression test.----Post the actual values.
Okay, I can do a compression test Monday or Tuesday, should I do the test with the engine hot or cold? I've never actually done a compression test, I've only worked in 4cyl engines and always done leak down test as I thought they were more helpful.
 

Jdepoy

Cadet
Joined
Sep 22, 2024
Messages
7
I agree, compression numbers and have you tested your overheat sensors and horn?
Okay, I'll do a compression test. And I havnt tested the overheat sensors but I did take my IR temp gun with me last time and when it boggs down and dies the cyl head and block are in between 145 and 160ish
 

Jdepoy

Cadet
Joined
Sep 22, 2024
Messages
7
Here is a pic of the plugs, im really leaning towards a weak spark when engune gets to op temp. Is there a way to test the power pack? Or just parts cannon and see what happens?
 

Attachments

  • 17271291241045087216071969229359.jpg
    17271291241045087216071969229359.jpg
    1.6 MB · Views: 8

cyclops222

Lieutenant
Joined
Mar 21, 2024
Messages
1,289
Those plugs are a good part of erratic engine power.
Install CORRECT new ones. Those may be wrong type.
 

Jdepoy

Cadet
Joined
Sep 22, 2024
Messages
7
Those plugs are a good part of erratic engine power.
Install CORRECT new ones. Those may be wrong type.
Those plugs have been in the engine for 2 months and have 3 runs on them, they are what the turbojet manual recommended
 

cyclops222

Lieutenant
Joined
Mar 21, 2024
Messages
1,289
Only time I ever saw 3 run times look like that. COLD running engine due to stuck open thermostat. My own engine.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
13,446
2nd Step: Does the Spark consistently jump a 3/8" Gap on all Plug Wires?

" they are what the turbojet manual recommended"

Turbojet Manual???
 

Jdepoy

Cadet
Joined
Sep 22, 2024
Messages
7
2nd Step: Does the Spark consistently jump a 3/8" Gap on all Plug Wires?

" they are what the turbojet manual recommended"

Turbojet Manual???
My bad, I should have clarified. The turbojet manual is the manual for the engine and jet drive in the boat. It's just a 115 johnson evinrude outboard mounted in the boat on a jet drive. Mines at the shop so I can take a picture of the page that recommends those plugs but this is what the manual looks like, and I'm not sureabout the plugs Everytime I've gone out on the water I havnt thought to pull the plugs and see what's happening with them after it's warm. I can this weekend and let you know.
 

Attachments

  • Screenshot_20240923_213508_Google.jpg
    Screenshot_20240923_213508_Google.jpg
    814.5 KB · Views: 3

racerone

Supreme Mariner
Joined
Dec 28, 2013
Messages
37,814
The " turbo jet "------Is the V-4 outboard powerhead mounted inside those jet boats 30 years ago.----Marketed for about 4 years at the time.
 
Top