Search results

  1. dpfundst

    2001 Yamah 90hp 2 stroke 90TLRZ wont run over 2000rpm intermittenly

    boat starts up great, runs great if boat sits for 2 hours our more, sometimes, after starting, when going to get up on plane, over 2000rpm, engine will kick , buck, sound like it will blow up, so I drop down under 2000rpm, and it will run smoothly back to the dock, if I accelearate over...
  2. dpfundst

    Yam 90LTRZ 2001 90hp 2 stroke hose crimped and dangling

    Hi I have a 2001 90 Hp 2 stroke Yamaha 90LTRZ (198 DLV) There is tube/hose on the front part of the motor that runs from the lower unit up to the top. This weekend it must have come off its clip. It got hung up under the motor when trimmed down and got pinched, it wore down in a couple of...
  3. dpfundst

    Ignition key on Yamaha 90hp 2 stroke

    90hp Yam 2 stroke 2001 To start the boat I need to turn the ignition key 3/4 turn clockwise to the right, then it starts. Same thing shutting off the motor, except opposite way. The Key / ignition seems to have "lossened up" or stripped a bit. I have to turn it quite a ways. Previous to this...
  4. dpfundst

    Yamaha 2001 90LTRZ oil drip appearing right side 2nd section of housing

    Started up the boat for the season, started right up.....while flushing out the "fogger" from last season, notice a slight drip of oil form on the 2nd section of the housing on the right side. Do I have a casket failing? Or soemthing else? How serious? Plan to go out tomorrow Thanks for the help...
  5. dpfundst

    90LTRZ vibration when trying to plane

    Hi, Have a 2 stroke 90Hp Yam 90LTRZ 20001. Runs great, but just now (and several other times) when heading home after being out on the beach all day, the engine starts up great, runs great at low RPMS but when I go to "hit it" and get on plane I get a vibration strong enough for me to back the...
  6. dpfundst

    Installing bow chock

    Hi, I am considering installing bow chocks on a 2009 Carolina Skiff 198DLV. Looking for tips, and what to watch out for. Any tips on drilling to prevent cracking of gelcoat? Should I use a backing to secure chock? or screws? 5200 to seal holes? Any help is greatly appreciated. Thanks Dwight
  7. dpfundst

    Yamaha website no longer shows 2 strokes??

    Hi, I have a 2001 Yamaha 90Hp 2 stroke, 90TLRZ I was just on the Yamaha website to a page I bookmarked that is no longer there 2 stroke Mid Range Anyone else deal with this? Thanks Dwight
  8. dpfundst

    question on lighting for night fishing

    Hi I have a 17FT Wellcraft Center Console with a 90Hp Yamaha 2 stroke A single battery a 9 Volt "cigarette lighter" plug on the console I have a Perko Mast Stern Light and a Perko Bow Nav Light I am looking for advice on additional lighting for the cockpit, bow area in order to have enough...
  9. dpfundst

    Anyone have experience with Seafoam DeepCreep?

    I have been considering Seafoam DeepCreep to help clean out my carbs etc. Does anyone on the site have experience using this? What results have you seen? Is it worth using to address, a rough idle in neutral on a 2001 90 HP 2 stroke? Thanks
  10. dpfundst

    Teak Oil on Teak Veneer Plywood ??

    I built a console door out of marine grade, teak veneer plyood. It looks great. I have teak trim around the boat which I recently added teak oil.<br />Should I oil the veneer face of the door?<br /><br />I noticed when it got wet, it had a water mark, that dried and disappeared, so I'm...
  11. dpfundst

    Installing a transducer ona stepped hull

    Hi,<br /><br />I am installng a transducer on my Wellcraft Center Console which has two steps in the hull design.<br />The manual says to install at least 15 inches away from the prop, and that additional turbulence is created just aft of strakes which I have 2 because of the design.<br />It...
  12. dpfundst

    Yamaha Multi-Function Digital Tach question

    Hi,<br />I have a 2001 90HP 2 stroke 90TLRZ with the multi-function digital tach. I am new to Yamaha.<br /><br />I ran the boat this weekend and it ran great, but on the Tach - the reading is a single blinking bar on the temp, nothing on oil, nothing on tilt. I am getting RPM readings, but I'm...
  13. dpfundst

    Suggestions on wiring/cablng install

    I have a 17 foot center console which has a "wiring channel" that runs from the console to the battery that is near the stern. This channel presently houses wiring/cabling for steering, a Yamaha 704 control, Multi-function digital tach, and VHS radio cable (from the previous boat owner). The...
  14. dpfundst

    2001 Yamaha 90HP 2 stroke 90TLRZ Starting instructions

    Hi,<br /><br />I have a 2001 90HP 2 stroke 90TLRZ which I bought this past November.<br />What is the recomended cold start procedure, other than squeezing the bulb until firm, and turning the key.<br />What about the choke on this model?<br />Any other tips?<br /><br />Thanks<br />Dwight
  15. dpfundst

    2001 Yamaha 90HP 2 stroke 90TLRZ - water flow question

    Hi,<br /><br />I have a 2001 90HP 2 stroke 90TLRZ I bought last November on an older Wellcraft Center Console. I put it in the water in November, it started and ran great. My question is: I don't seem to get all that strong of a water flow while running it in idle on "rabbit ears" or while...
  16. dpfundst

    Replacing Doors on Center Console

    Hi,<br /><br />I have a 17 Ft Wellcraft Fisherman that I am replacing the center console doors.<br />I have removed the "frame" that bordered the rough cutout. I am looking at Starboard ready made, custom-made, and possibly teak.<br />Anybody have some ideas or suggestions??<br /><br />Thanks
Top