Search results

  1. S

    evinrude pl-88 load adaptor

    10 ohm, 10 watt resistor per manual
  2. S

    What glue secures the charge coil to the lamination assembly?

    Hey guys, I'm replacing the coil only. What kind of glue should I use to secure the coil to the metal part? What do I use to remove the old glue and clean the metal part? Thanks for your help!
  3. S

    Just Cut out the Kill Switch?

    I'm fortunate enough to live near the Monterey Bay in California. I'm getting a lot more halibut than salmon last few years mainly because it's easier and more relaxing than chasing salmon in open water. And halibut keeps better than salmon vacuum packed in the freezer!
  4. S

    Just Cut out the Kill Switch?

    Good points. I'll just replace it. Thanks everyone!
  5. S

    Just Cut out the Kill Switch?

    I never use it and it may need replacement. I may just replace it but checking my options to 'bypass' it.
  6. S

    Just Cut out the Kill Switch?

    Yes
  7. S

    Just Cut out the Kill Switch?

    Yes
  8. S

    Just Cut out the Kill Switch?

    I'm replacing the ignition switch and I don't want to maintain the old separate kill switch in the circuit. Can I just cut those two wires coming out of it or would that cause any other problems in the ignition circuit? It just kills the motor right? I don't need anything else killing the...
  9. S

    Correct Float Seat Assembly for 1995 J48ESLEOS

    Thanks Faztbullet! I just ordered seat assembly #387262 and the pic looked promising!
  10. S

    Correct Float Seat Assembly for 1995 J48ESLEOS

    Perhaps. The number stamped on my carb is 339169, which is different, and I can't seem to find the seat assembly for it. Thanks
  11. S

    Correct Float Seat Assembly for 1995 J48ESLEOS

    Hello, I have a 1995 48hp Johnson #J48ESLEOS and the last two times I ordered the 'correct' carb repair kit #396701 including name brand OEM parts, I get a smaller diameter seat that does not fit. I am trying to fix a fuel leak and want the correct, larger diameter seat and matching fuel pin...
  12. S

    Has anyone had detrimental effects from soaking carbs in carb cleaner?

    I soaked my 1995 Johnson 48SPL carbs over night and have not managed to figure out a fuel leak after 3 or 4 attempts. The fuel pin was seating on the seat adequately per pressure test, however I could not get the right new seat for my carb despite the parts # being correct. I just ordered 2...
Top