Search results

  1. D

    Electrical Diagram in Service Manual doesn't match the stator wiring

    Trigger wires are the same color in pairs, the only difference being the yellow sleeve, so nothing but the sleeve to match up with. The old one was hooked up with trigger and stator 'yellow sleeves' to the bottom switch box, so I'll do that again. I just hate irregularities in service manuals!
  2. D

    Electrical Diagram in Service Manual doesn't match the stator wiring

    Has anyone noticed that the Mercury service manual wiring diagram doesn't match the OEM Mercury stator? I'm installing one in a 1986 90hp 6 cyl outboard. The new stator (398-5454-A18) has the yellow sleeve around the blue/white and red/white striped wires, but the schematic shows the yellow...
  3. D

    Mercury outboard stator question

    They're on their way - wondering if the culprit was the stator with a high reading on one side (see original post)
  4. D

    Mercury outboard stator question

    One side is a bit high (specs in original post) - the leads to the upper switch box are reading 650 ohms high. Wondering if that's within enough tolerance to safely ignore, or is there a risk of damaging another component.
  5. D

    Mercury outboard stator question

    1986 Merc 90hp 6 cylinder adi ignition, carb model. Ran like a champ last weekend now no spark on 4 cylinders (only 1 and 5 good, haven't tested coils yet). When troubleshooting the system, I have a rectifier with shorted diodes, and a stator with a slightly high reading on the red/white to...
  6. D

    Mercury 50 HP .464 expained? Timing my 50 HP

    Sorry, last bullet should be: -Now go back clockwise to .436, and align the plastic timing indicator near the flywheel to .464. and proceed to check the timing.
  7. D

    Mercury 50 HP .464 expained? Timing my 50 HP

    Hey - Just chiming in here years later to clarify if anyone is aligning their timing mark. This works on my 1986 Merc 90 ADI Inline 6. -Run your hose so you don't screw up the water pump impeller, and remove your plugs. -Then install the dial indicator tool in the #1 plug hole and turn the...
  8. D

    1986 ELPTO Mercury 90 Enrichener valve question

    Question on the enrichner valve assembly (part #42859A2 on merc's parts site) Does it matter which nipple on the enrichner the fuel lines are attached to? It's just an open/shut valve, right?
Top