Search results

  1. J

    No start with key

    Right the issue is no crank with key. I will check for voltage and see what I got
  2. J

    No start with key

    Good day...boat was starting fine with key...and now will not...I replaced soliniod thinking may be then issue...still no...I can jump soliniod and it starts...just not with key...
  3. J

    Trailer dog tracking

    Ok I will thanks for the info
  4. J

    Trailer dog tracking

    Gotcha thanks
  5. J

    Trailer dog tracking

    Makes sense...thanks
  6. J

    Trailer dog tracking

    It doesn't sway back and forth just aims to the curb it seems...not sure how to check tounge weight or adjust it
  7. J

    Trailer dog tracking

    Good day. My trailer doesn't seem to go down the road straight. When I'm pulling it looks like in the mirror that it's kinds doing the sideways dance...any suggestions
  8. J

    Y pipe

    I'm going to pull it back to dock
  9. J

    Y pipe

    Like the oil pan or what...how deep can or does it need to go
  10. J

    Y pipe

    I was looking back towards inside of transom so by left side I meant starboard side..I am going to take it back to water tomorrow and see if what I've sealed stopped it...if not I'll pull drive and check the ring inside like you suggested
  11. J

    Y pipe

    Alright so I've ran boat for an hour in driveway...no leak...my conclusion is it's not y pipe...I have checked all bellows and snughed up clamps...also pulled the plugs leading into steering arm are and sealed them. Also ran another good wide bead of sikaflex around bellhousing and around the 2...
  12. J

    Y pipe

    Early alpha 1 sorry
  13. J

    Y pipe

    Ok so after reinstalling a new bell housing gasket...housing..outdrive...y pipe...and engine. I had it fired up on hose and there was no leaks anywhere aside from a bad clamp. I took it to dock today and just backed in and fired it up and ran it...I've got a leak and it appears to be left side...
  14. J

    Stringers

    That is kinda what I figured. I can honestly say it has way more strength now then it did when I pulled it apart no bulkheads...rotten and soaked stringers. Rotten and soaked transom.
  15. J

    Stringers

    That portion is done...it's from there forward that isn't...it's wide open for me to finish.
  16. J

    Stringers

    Good day....I have finished my transom and engine and outdrive back in place. Stringers are tabbed in but not finished. I need to move my boat about a 20 min drive. Is it safe to do so or will I crack something
  17. J

    Alignment tool stuck

    Outdrive slide right on...had to turn prop twice and she slid home
  18. J

    Alignment tool stuck

    I went and bought a good slide hammer set...welded a chain on straight...a few smacks and out she came. I them did some trial and errors and got the tool sliding fully in and easy out. Thanks gentleman
  19. J

    Alignment tool stuck

    The drive came off easy and I didn't change bearing. What did change and I should have mentioned is the transom has been rebuilt. I'm guessing the holes are off a tad. Can't be much though or it wouldn't have slid in relatively easy. I'll weld
  20. J

    Alignment tool stuck

    Ya it ain't coming out...I don't get it...shall I raise or lower engine mounts ...
Top