Search results

  1. B

    Is this oil pressure normal?

    Measure 9V on the oil pressure gauge. When the gauge stops working the multimeter shows 16V. Very strange. Maybe I just should disconnect 12V + and - and just hotwire from the neighbourinstrument?
  2. B

    Is this oil pressure normal?

    Thanks. Will be hooking up a multimeter to see what wire causes the failure, either the sensor cable, +12v or ground :)
  3. B

    Is this oil pressure normal?

    That is just the sun/light reflecting :)
  4. B

    Is this oil pressure normal?

    I have tested with a new gauge. The oil pressure sender is new. Will try to put a new wire from sender to gauge.
  5. B

    Is this oil pressure normal?

    I just bought the boat. I will empty one litre tomorrow to see if oil pressure gets better. I really dont hope there is diesel in the oil, but I cant smell it or see it on the paper I wiped.
  6. B

    Is this oil pressure normal?

    Oil is above maximum mark. It should be between. I had the dipstick outside engine a few hours before putting it im to avoid residue from dipstick tube.
  7. B

    Is this oil pressure normal?

    Oil level seems to be over maximum. Will remove some to see if that fixes the problem
  8. B

    Is this oil pressure normal?

    Mercruiser 1.7 turbo diesel 2007. Two different gauges. I have changed oil pressure sender. The needle jumps a lot. What could cause this? Sometimes it stays on 0 for a few minutes before it goes to normal. No smoke or other strange noises. Engine runs fine.
  9. B

    Hard to get into neutral after reverse

    Sounds like the gears are hitting each other. Shouldnt it be silent?
  10. B

    Hard to get into neutral after reverse

    Hello. I have a mercruiser 1.7 engine with alpha one gen 2 drive. Last year I changed gimbal etc.. If I go from forward to neutral, it goes well. If I go from reverse to neutral, it can be a little difficult to get it in neutral, I almost have to put the gear lever forward. What do you think...
  11. B

    Bennett trim tab won't calibrate

    Hi. i replaced both trim tab upper hinge because one sensor didn't work. After replacing them I need to calibrate them.on the eic5000 panel. Port and starboard red led flash alternately. i press the sun and moon for 3 seconds. I press both tabs down. But the port and starboard upper yellow dont...
  12. B

    Mercruiser 1.7 dti: How much engine oil and coolant?

    Hi. How much engine oil and coolant goes into Mercruiser 1.7 dti? (Apha one gen 2 sterndrive). Boat is from 2006.
Top