Search results

  1. J

    84 Mercury 25XD won’t tilt!

    Back from a few years hiatus with a boat, got the itch again and picked up a decent boat for cheap. I have gone through this 84 Mercury 25XD, and the last thing I think I need to solve is...I can't get it to tilt unless I remove the pin. YES, I do have the washer on the shift shaft!! I know...
  2. J

    To big of an engine?!

    I have a 1980 bass tracker with the original 40hp Mercury 2 stroke. After assembling the ol girl from bags and bags of parts and finishing my boat build to fishing it a few times. 40hp only gets me to 22ish mph with gear 2 people etc. I have a chanct to scoop up an old early 80s 2 stroke...
  3. J

    1980 mercury 40 hp fuel line routing.

    I have a 1980 mercury 40 hp I got with a boat. The carb and fuel pumps were in a bag of parts. i have rebuilt the carb and the fuel pump. As I was going through the service manual, I can’t seem to find my fuel pump #62973. Along with not being able to find this pump for fuel line routing...
  4. J

    1993 Mariner Magnum 3, issues while in the water...???

    I had my Mariner Magnum 3 running like a top in my driveway with the hose kit on it. Felt like it was ready for the water...and got it to the lake, but had nothing but issues. 1- Took a little bit to get started and idle was barely enough tonrun. 2- After adjusting idle up a little and...
  5. J

    Mariner magnum 3 150HP....temp sensor

    I would like to install an aftermarket temp sensor for my motor, can anyone provide info on where to locate it?
  6. J

    1993 Mariner Magnum 3, fuel issue?

    Just got a new to me bass boat, with a Mariner Magnum 3 150hp outboard. The boat was sitting for almost a year, so obviously engine needed to be cleaned out. But before it was stored for a year it supposedly had a tune up and tank filled with gas..yuck. Anyways went through the carbs and the...
  7. J

    71 Chrysler flooring questions, no stringers

    I've been reading for over a month on things I think I need to tackle with my new to me boat. Finally got it to my house, wife is letting me put it in the garage, today I started Project Grumpy Cat. After ripping out the old seats and and carpet the floor was made of 1/2" particle plywood. I...
  8. J

    Chrysler 75hp outboard...parts

    Recently aquired a Chrysler Bowrider with a 75hp motor. I have been scouring this site for every thing related. I have found a few sites besides eBay for maintenance parts. But.....are all these motors parts compatible they always list multiple HP rated motors. Afraid to order parts and have...
  9. J

    Stupid newb hull repair questions.

    New to this forum but not to tinkering on projects! I have a couple questions that I can't seem to get a zeroed in answer on. I've searched on here for pictures and 100 videos on youtube. So I signed up so I can learn from the great help on here. I aquired a 70s Chrysler Bowrider with a 75hp...
Top