Search results

  1. K

    1968 20hp Johnson leaking unburnt fuel into water

    Thanks guys. I'll investigate those potential items.
  2. K

    1968 20hp Johnson leaking unburnt fuel into water

    Thanks for your reply Racerone & Dingbat, but this is not a normal amount of unburned fuel. I've owned many outboards and this engine I have owned since the 70's and it has gotten worse over the past few years. Something has recently changed and that is why I'm looking for a potential fix...
  3. K

    1968 20hp Johnson leaking unburnt fuel into water

    I have a 1968 Johnson 20hp outboard (Model: FD-22M) with an odd fuel leak seen on the water surface. I can smell that it is unburnt fuel and it "rainbows" on the water surface. I thought it was potentially piston blow-by but I tested cylinder compression and both cylinders have great...
  4. K

    1976 9.9hp thermostat seal orientation

    I'm looking for info on the direction of install for the thermostat seal - The Seal Part#: 0310058. There is a lip on one side of the seal. Is it suppose to be facing up towards the top of the thermostat or down? The seal I am removing is in such bad condition it is not evident which way it...
  5. K

    Johnson 9.9hp armature pilot location - Model 10E76H

    Thanks for the reply. I will take a look at it tomorrow. From a curious standpoint, what does the larger plastic Armature Bearing do if it doesn't pilot the armature?
  6. K

    Johnson 9.9hp armature pilot location - Model 10E76H

    I was trying to verify the point settings on my 1976, 9.9hp Johnson motor and I noticed the Armature Plate is sloppy side to side which influences the points gap because of that movement. I also see contact between the coils and the flywheel which tells me there is too much movement. I have 2...
  7. K

    Minn Kota e-drive - Reverse only

    I have a 48 volt, MinnKota e-drive with reverse only, no forward. I'd like to root cause the controls assembly to see if the issue lies there. Does anyone have info on the connector schematic going from the controls to the motor, so I can check continuity through the pins in forward and...
Top