Search results

  1. S

    97 johnson 200 Throttle body help

    Thanks all. Will order new
  2. S

    97 johnson 200 Throttle body help

    No sir, 1 month old tops. Yes they came with the carb kit, not bought indivually. Would i benefit from ordering just these vs replacing the kits? I know the place will warranty them, just wasnt sure if i should order differently.
  3. S

    97 johnson 200 Throttle body help

    Packaging looked new. But could have sat i guess. Pretty busy repair shop tho here in south florida. Hard to believe these kits would just sit. I will reach out to them in the morning.
  4. S

    97 johnson 200 Throttle body help

    10 sounds right to what i set it at.
  5. S

    97 johnson 200 Throttle body help

    Lighting was bad, these are brown. Should they be black?
  6. S

    97 johnson 200 Throttle body help

    Parts came from local johnson dealer. Part number 437327. I really dont remember the torque spec. I have to dig for it.
  7. S

    97 johnson 200 Throttle body help

    Hello all, i have a 97 johnson 200 that i recently rebuilt the carbs on. Things were running great, then encountered rough idle. Got it home, found cylinder #3 carb was stuck open. Found debris in float needle, coudlnt get it to reseal, so i rebuilt, was running great in driveway and on way out...
  8. S

    Key ignition help

    Hello everyone, My key switch broke and i am having trouble tracking down what i need. I have a 75 bayliner with a 87 force 125. The old switch was a 6 terminal long shaft 3 position with terminals B,C,M,M,S and A. I found mp39090 at west marine, only difference is the A terminal was a I. Motor...
  9. S

    Tach replacement question

    Hello, my tach quit and I ordered a new one. The dial on the back is different and I want to be sure I wont ruin it before I install it. The old one has 1,2,3,4 and new only 2. Not sure what those mean. Can someone take a look please and let me know. I have an 87 force 125. Thank you
  10. S

    Trim parts needed please

    Hello all, I'm at the end of my resources and really hoping one of you can help. I need part #42 on the diagram. Any chance someone knows where I can track this down? thanks in advance for any help.
  11. S

    Force 125 revs too high?

    Hello, I tried researching this but seem to have the opposite issue going on. 1987 force 125 that starts and idles great. I do not have a tach. It failed a week ago. Just waiting for replacement. But by ear is idling in the proper range. When I put it in gear, this motor wants to go! I'm...
  12. S

    87 force 125 clutch dog?

    Hello all. having an issue, pretty sure it's the clutch dog. Just wanted opinions before I dig into it. I was fishing recently and while at WOT, felt a large thump and boat slowed. Was able to run half throttle back to ramp. I have noticed that when turning prop by hand, the link at the top of...
  13. S

    1987 johnson 48 special idle help

    hello all, I am having issues with my motor i cannot figure out. I have a video but can't seem to upload, so I'll try to explain. it sounds like this motor will fluctuate to me greatly and has an intermittent backfire. 100 hr service performed on it. timing possibly? carbs not sync' d properly...
  14. S

    1987 force 125 fuel pump help.

    Hello all, ive got an issue i just cant seem to figure out. My fuel pump diaphram keeps blowing out. I have changed it twice in 8 months and it failed again today. Ran fine going out to the spot, turned motor off, fished for an hour, started it up and it was bad. Any ideas or help is much...
  15. S

    1975 bayliner knowledge needed

    Hello everyone, I really could really use some help here. I stumbled upon a 75 bayliner quartermaster 1900 in damn near mint original condition. Old guy had it in his garage it's whole life I think haha. Anyways, now I want some information on this thing. This is going to sound stupid but I've...
  16. S

    force 125 tilt/trim help needed please

    hello, I recently purchased a 1975 bayliner with a 87 force 125. yesterday the tilt/trim quit on me. it currently has an arco 3 wire that's wired to a switch in the dash, no switch in the throttle control. that motor I'm pricing at 350. here is my question. since it's an aftermarket switch, can...
Top