Search results

  1. R

    Bow Rail

    on a 1988 sea ray cuddy is the bowrail sectioned together or is it one full piece star to port
  2. R

    250 Sea Ray cuddy Deck and Beyond

    hello members I took this photo from another post because its same as what I am considering tackling same boat 250 sea ray cuddy. I've never did anything like this before and must admit I'm a bit intimidated. I would like the challenge but was wondering if its possible, I wont ask if its worth...
  3. R

    fuel tank advice

    doin research on my 250 searay fuel system when deck is removed stringers transum replaced wondering is I should replace fuel tank with plastic or aluminum again I removed the aluminum tank also wondering if they can be tested or just go new its 88 model 30 year old didn't just want to put back...
  4. R

    My 250 CC resto

    when removing and replacing transum and stingers bulk head ect.. does the hull have to be cradled ? I was wondering if when removing the stringers will it cause the hull to sag even slightly ?
  5. R

    Can Cedar handle it

    can cedar be glassed over? I was researching this so when I start my R&R of transum and stringers bulkheads wondering if it would work for motor mount surface 4x4 type
  6. R

    original spec's or blue prints

    I was wondering ir there is anywhere i can find the original plans or prints on a 1988 250 Searay Cuddy i have read that on transum repair is straight forward but that the stringers that connect the transum to the first bulk head in the engine compartment lays directly on the hull and is not...
  7. R

    How much epoxy

    I am on the ground floor of a transom and stringer refit on a 1988 searay cc 8' beam i was wondering how many gallons of epoxy to get a job like this done?
  8. R

    searay 250 cc

    does anyone know if there a resto involving a searay 250 cc I'm researching a r&r a transom stringers ​and was wondering where to remove the deck to get access to the lower end thanks roy
  9. R

    454 intake Manifold

    Hello has anyone replaced a mercruiser cast iron intake with an aftermarket aluminum unit ? ​I was wondering if everything would line up Thanks roy
  10. R

    Rubbing On Gimbal Ring

    I just purchased a complete fresh water gimbal housing and noticed what appears to have been rubbing on the lower starboard ​side of the gimbel ring. it runs along the bottom from forward to aft as if the out drive would have caused it from trimming in and out I was wondering what could have...
  11. R

    Mercruiser fly wheel housing / rear engine mount

    when pressing in new bushings do they go from bottom up or top down ? I heard the housing opening were tapered. thanks roy
  12. R

    Bravo 1 gimbal housing

    The studs that are on the gimbal housing can they be replaced ? do not want to put gimbal back with same studs thanks roy
Top