Search results

  1. waterboy84

    Audio

    Quick question. I bought a boat and the radio that was in the boat did not work. Hell the radio was so old it was the radio that had a tape deck on it. Anyhow i went and bought a new radio with cd player. No i didnt get a marine radio becuz where the radio was installed there is no possible...
  2. waterboy84

    Shifting

    Ok so i took my boat out to the lake yesterday to run it alittle due to havnt ran my boat much this year so i wanted to put it in the water and run it for a bit to keep parts moving and lubricanted. Anyhow i have a 95 maxum with a 120hp force. When i put boat in the water i put boat in reverse...
  3. waterboy84

    Rpms

    Ok so i been having this problem that i have never had before and i just cant seem to figure the issue out. I will explain issue in full detail on the syptoms and what the motor does. So the motor will start up perfect and will idle perfect. When i take off and run the boat at wot ill will...
  4. waterboy84

    Compression

    I did a compression test on my 120hp force just to make sure compression is ok. Cyl 1=155 Cyl 2=170 Cyl 3=170 Cyl 4=165 Do these number look ok for compression. I personally feel like those compression numbers are high. However im not sure thats why im posting this to ask. I did the...
  5. waterboy84

    Terminals

    Does anybody know the terminal size thats on the trigger that connects to to switchbox. I dont wanna put anything bigger or anything smaller. Not sure if it would matter if i put bigger or smaller but would like to put the same size back on. The info would be much appreciated.
  6. waterboy84

    Timing

    Ok so im trying to set timing on my 120hp force. I understand its gotta be set at 28degrees btdc. My question is being the trigger control arm that connects to the tower shaft is almost a inch wide what part of the trigger control arm do i use to set the 28 degrees at. Or do i set it at the...
  7. waterboy84

    Timing

    Can some give me some knowledge of a step by step on getting my boats timing right. I have a 120hp force. My boat was running great until one day it just died. I figured the stator went bad so i took fly wheel off along with the trigger and stator ready to put a new stator. Well after talking to...
  8. waterboy84

    Gear lube

    I have a 120hp force im trying to get lower unit gear lube changed. Can i use the supertech 80w90 from walmart. If not what would be a cheaper but good recommended gear lube i could use
  9. waterboy84

    Gear oil

    Im in the process of changing the lower units oil but im alittle stuck on what kind of oil/lub to put back in it. I have a 120hp force what kind of oil can i put in it when i drain the old thanks for the info
  10. waterboy84

    engine rebuild

    I got a 97 kawasaki 1100zxi and would like to get some info on this rebuild. What are the steps and things i need or should replace when doing the rebuild. I am mechaniclly inclined and have lots of knowledge on mechanical work however i never touched a 2 stroke jetski motor. Thanks for the info.
  11. waterboy84

    drive shaft housing seal

    Gotta replace the drive shaft house seal on the lower unit of my 94 120hp force motor. Not sure what im getting into but was told its not that hard of a job. Just wanted to get some info on what im in for and maybe alittle knowledge on what to do to change the seal. Thanks for the help
  12. waterboy84

    carburator

    Ok so i have a 97 kawasaki1100zxi. Im having trouble getting fuel to fill up in the fuel filter. Any info would be help on why carburator isnt pulling fuel.
Top