Search results

  1. J

    1996 sea ray 250 horn location

    thanks for the info, i got it switched, seems the machine screws have a threaded plate on the inside, easy to remove, had to have help installing it, as one person has to hold the bracket in place on the inside while another turns the screws into the bracket.
  2. J

    1996 sea ray 250 horn location

    thanks that's where it is, looks like quite a chore to remove from inside, that outside cover bolts seem to just spin, does it have to be removed from the inside?
  3. J

    1996 sea ray 250 horn location

    Hi again everyone, i recently bought a 1996 Sea Ray 250, i have an issue with the horn, it did work two times, now nothing, i've checked the breaker, and switch, i can't find that horn anywhere on the boat, when it did work, i thought the noise was coming from somewhere near the Helm, i removed...
  4. J

    installing 12v to 120v inverter

    Hi again everybody, thanks for the tips,
  5. J

    installing 12v to 120v inverter

    the inverter will only be used for sort periods of time when i'm at sea. it will be used to run a small appliance like a blender, to mix bait.
  6. J

    installing 12v to 120v inverter

    the inverter will be used for short periods, while i'm at sea, just to run a small appliance for a short period
  7. J

    installing 12v to 120v inverter

    thanks for your reply, by backfeed i mean that i connected the out put of the inverter to the nearest 120v plug, thinking it would energize all the a/c circuit. I have two marine batteries, the inverter would only be use on short time frames, like running a small appliance for a short period of time
  8. J

    installing 12v to 120v inverter

    Hi, all, i installed a 2000w 12v to 120v inverter on my 1996 Sea Ray 25ft sun dancer, there was plenty of room in the engine compartment and a 120v receptacle near by, I thought i could install the inverter and back feed the 120v receptacle to power the rest of the boat with 120v power. Seems...
  9. J

    overheating problems on mercruiser 470

    actually i did, when i changed the impeller and housing, and still had the problem, i removed it "again" to inspect it to make sure i didn't fry another one, that is when i back flushed the system from the small cooler/heat exchanger, until i had a good stream of water coming out of the copper...
  10. J

    overheating problems on mercruiser 470

    thanks for the info, when i attempted to take it off, i used a screw driver and a hammer to try to dislodge it, but it didn't budge, i didn't want to do anything else before i had a chance to talk with some one about it
  11. J

    overheating problems on mercruiser 470

    Hi, all, i have a sea ray with two 470 mercruiser engines and outdrives. the starboard engine has a heating problem, it seems i fried the impeller on the out drive, after i replaced it the heating problem began. I have checked the thermostat, it tested okay. i think the problem is my heat...
  12. J

    1980 Sea Ray Sundancer Battery problem

    thanks for the advise, but there is no way i have access to the inside bottom area of the transom, without pulling the engines, there is no room either side of either engine to gain access, the only way i can look around down there, is to take my camera and take pictures, or short videos just to...
  13. J

    1980 Sea Ray Sundancer Battery problem

    I'm taking your advise and looking for possible problems with transom, when you said do test drills, just where would i do the drilling? with the two 470 engines, there is not much room to access the inside of the transom, would you drill from the outside and patch the holes with resin?
  14. J

    1980 Sea Ray Sundancer Battery problem

    also, i measure the mystery voltage, at the solinoid, and at the distribution panel in the boat, as said earlier, i've disconnected the positive battery connections, unplugged the main connector on the engine, and the voltage is still there. I have all wiring, that i know of going threw the...
  15. J

    1980 Sea Ray Sundancer Battery problem

    I switched because it was cheaper, a new regulator costs, about $600, and would still not be sure if the problem might be in the stator, a change out only cost about $200, and i trust a alternator more than the original set up. i have tried to check for amperage at the batterys, but according to...
  16. J

    1980 Sea Ray Sundancer Battery problem

    also, if i leave the battery connected overnight, it will drain the battery.
  17. J

    1980 Sea Ray Sundancer Battery problem

    When i bought the boat, the engine would turn over but not fire, i chased wires for five days, took it to a shop, they said the regulator most likely had a bad diode, so went with the alternator conversion, They also replace 3 wires from the engine compartment to the main board, got it running...
  18. J

    1980 Sea Ray Sundancer Battery problem

    i don't know what is on the boat that could possibly hold a charge, except a battery. i just have the standard, GPS, fish finder, Windlass. none of these have internal batterys.
  19. J

    1980 Sea Ray Sundancer Battery problem

    i have taken the positive leads off all the batterys, just to make sure i'm not getting some kind of feed back, the voltage is still there, it will discharge rapidly if i turn on cabin lights.
  20. J

    1980 Sea Ray Sundancer Battery problem

    i did some more testing, when i energize the battery switch to on, for a few minutes, then turn it off, i get voltage that slowly drains down to 1 then zero, if i have the cabin lights on, and do this, it drains down to 1 then zero very fast, i'm sure there has to be a battery somewhere, i've...
Top