Search results

  1. F

    Timing Question...........

    Hi, will Joe Reeves WOT timing procedure apply to a 1985 25hp Evinrude. Where would be the timing marks on this flywheel? Pic: http://i190.photobucket.com/albums/z287/flconrad/Manatee%20boat/202530_Eng-Elec-PH-3_zps6319fc52.jpg
  2. F

    Do I need a different Carb? If so, where to get one?

    Hi, Got everything else worked out on my motor, now I am down to the carb being the only problem. Now, when it runs, it floods itself, runs too rich, and floods itself to a halt. I have taken the carb down twice with entirely new kits each time, float and all. I am beginning to think this is...
  3. F

    1985 20hp Evinrude (Belgium) What type of sneeze or miss is this? Video inside

    Hello again, Been working on this outboard for a while now. 110 comp on each cyl. New stator, trigger, coils, plugs, wires, rebuilt carb with new low speed needle and gasket, and fuel pump, rebuilt manual primer and replaced lines with oem ones. Only thing original on this is CDI. After...
  4. F

    1985 20 hp Evinrude Flywheel hitting stator coils

    Hello, I have been having a bad sneeze on acceleration after warm up. Pulled the flywheel, inside of flywheel rubbed and stator coils rubbed. I have attached pics. What would be causing this? Plate is tight. Also, should the flywheel be able to go down the spindle more and be flush or are...
  5. F

    Need advice on best way to get this oil seal out and off propshaft.

    Hi to all, I haven't posted in a while and figured I was boatless for too long. Picked up a small skiff with a 1985 20 hp Evinrude on it with a 1997 lower unit. Pulled the prop and past the thrust washer I found one oil seal in backwards and the second one jammed in backwards too. Got the...
  6. F

    What would cause this???....

    Hi, 2006 Bravo 3 outdrives. Boat would not get on plane, had it pulled in the yard. My mechanic says I hit something. I never felt anything and there are no marks on the outdrives. Any opinions or is this from an overheat or corrosion?? Thanks in advance...
  7. F

    Model and year of my Merc

    Hi, I have seached the links to model and year in the FAQ's but I am still not sure. I have a 175hp Mercury s/n 5921200. Could someone help with model and year? Thanks in advance!
  8. F

    What year is this 200 Evinrude I just bought?

    Hi,<br /> I had posted the below previously. I now need to find out if this is a '94 as I have been told by who sold it to me. It is rusted so bad that the model tags are off and all I can find on this motor is 27ASPH and G1415673 I want to make sure it is a '94 so that I buy the right...
  9. F

    Fuel problem on OMC jet

    Just wondering if anyone could kindly help me out with a question or two about the '95 Rage 15' 115hp omc boat that I just picked up. Previous owner has taken out the vro oil box and cut and plugged the lines near the fuel/oil pump and unplugged the harness from this pump. The engine is...
  10. F

    Fuel Pump on '95 Rage w/ 115 OMC

    Where would the fuel pump be on this Boston Whaler Rage 15' 1995 115hp v4 OMC jetboat? :confused: <br />After priming, it will only run until runs out of the gas that was primed into it. The VRO lines are sticking out of a can like cylinder in the engine compartment and are cut and plugged...
  11. F

    Stainless bolts on trailer coupler?

    I needed to replace my 2" coupler. The old one was bent. It is only held on by 2 bolts to the frame of the trailer and they were rusted. Bought 2 new stainless bolts and lock nuts to replace them. Friend of mine said do not ever use stainless fasteners because they will snap because they are...
  12. F

    Force Transom bracket size

    '98 Force 40hp- Are the transom brackets different sizes on different hp's- or- are the brackets all the same size and just the motors keep getting bigger? I am wondering because I have no tilt or trim on my 40hp and have been offered a unit off of a 90hp. Would this work?<br /> :confused:
  13. F

    Where to find Force 40hp '98 Tilt/trim entire unit?

    My 40hp Force 1998 did not come with tilt and trim. Where would anyone suggest I find this unit? Used is ok. I have seen the CMC tilt units but prefer type that would have been on there originally. Thanks
  14. F

    '98 Force 40hp Steering arm

    Hi,<br /> Just pick up a '98 Bass Tracker 16w/ '98 Force 40hp. Motor will steer completely to the right to make a tight turn, but turning left, motor will only turn slightly because rod is all the way in the tube. Unhooked steering arm and centered motor and steering wheel and it seems like...
  15. F

    Prop for 5hp sears gamefisher

    Hi, where can I get a prop for my 5hp model # 225.587500 '88 Gamefisher. The old one is plastic and lost a blade. It says 7 1/4 x 6 1/2 rh. Also there is a small nose cone that is just cotter pinned on the end of the prop shaft that I would like to find a replacement for too. <br /> Thanks :)
  16. F

    RePost of Gamefisher Question....

    Hi, Just picked up a like new Gamefisher 5hp. It has model # 225.587500 and sn# 2826 .The owner told me it was a '92<br />Does anyone know what fuel connector to use for it? Also, what would the fuel/oil mix be for this motor? Thanks in advance for the help. :) <br />flfisher
  17. F

    '92 Gamefisher 5hp w/ 10hrs

    Hi, Just picked a like new '92 Gamefisher 5hp.<br />Does anyone know what fuel connector to use for it? Also, what would the fuel/oil mix be for this motor? Thanks in advance for the help.<br />flfisher
  18. F

    small outboard hp question

    Hi,<br /> Would anyone know what is or was the largest small outboard available with an internal tank?<br /> I have no room for an external tank on my modified duck boat. Thanks
  19. F

    Need help finding year of Chrysler

    Hi,<br /> I have just bought a Chrysler 4 hp model# 4289F<br />How would I tell the year for parts? The SN is missing.<br />Thanks guys.<br /> :)
  20. F

    Suzuki DT85 '88-Removed thermostat,black oil out of foot

    Hello,<br /> I have 2 concerns today. Motor has been running hot-took thermostat out as prescribed by my mechanic. Will engine ever run too cold now here in Fla.? Or should I locate a new thermostat? Since removal of thermo., black oil runs out of foot after running engine on muffs? Not a whole...
Top