Search results

  1. hall832

    Can you guess how much I paid for all this?

    when a customer says " i got a good deal " i hav e to try hard not to laugh.
  2. hall832

    2003 Yamaha VX200TLRB VMAX. can run at 3600 rpms fine, try to get 4000 rpms dies.

    It seems like its losing fuel pressure. Had it at the boat ramp last night. it can run at 3000, 3600 rpms no problem. but as soon as i try to get 4500 rpms it stumbles once or twice and dies. checked last night still have voltage to ECM. still have voltage and a good ground to VST. After it...
  3. hall832

    1994 johnson 50 J50PLEEA wont idle. I am ready to blow this motor up

    I am ready to blow this motor up. I have checked everything except reed valves and ripping into the block. carbs gone through by me(with kits) Check comp good, fuel delivery good. fuel primer good. it will only idle for a couple seconds. then it wont restart. once plugs dry out it will fire up...
  4. hall832

    Indmar 5.7 310 HP, What is the best carb to run on the set up.

    Running twin Indmar 350's with timing at 10 @ 1000 rpm's and -32 advanced. the Holley's that came with the new motors don't seem to be a good fit. has anyone else changed out the carbs and if so to what.
  5. hall832

    Indmar 5.7 carb timing procedure. ? Base timing?

    I have read Timing procedure for the 5.7 Indmar 10 @ 1000 and 30 @ 3000 but do you have to use a shunt tool on a a carbed motor. sorry no serial numbers
  6. hall832

    2006 Optimax 90 hp ecm failure, send ecm out for reflashing.

    Send out the ecm to Simmons motor sports to flash the ecm. Any of you ever have experience with this.
  7. hall832

    2004 Mercruiser 6.2 Bravo 3 Still over heating

    Overheat alarm coming on. Put on a new impeller.Overheat still. I was getting no water to the raw water pump. Impeller was shredded. I checked the flow to the raw water pump nothing. I tried to back flush it and nothing. I then replaced the impeller, rerouted the water pick up from the bravo...
  8. hall832

    2006 6.2 Mercruiser. Bravo three. ate impeller. no water to the raw water pump.

    I am stumped. Pulled raw water pump today after overheat. The impeller was dust. I checked everything I could. The raw water pump is not getting any water. There is blockage between the pick up in the lower and the hose to the raw water pump. Does any one have any idea what the heck.
  9. hall832

    mercury v200 no fire on two cylinders.

    Not sure what year the motor is. I have checked comp. All within 5 lbs of each other. Coils are good. I don't have fire to the two middle cylinders.
  10. hall832

    Changing Fuel Filter on 5.0L EFI

    Re: Changing Fuel Filter on 5.0L EFI i realize i am gonna catch some crap for this. I am not saying its ideal but it will work. i have had to do it to fuel and oil filters. i push the screw driver in one side to the other.
  11. hall832

    Need timing procedure for Mercruiser 454

    Need timing procedure for Mercruiser 454, dropping a whole new power plant in a 1989 Formula 292. dropping in the distributor and its been a while since i have done this. have all the tools i need. any help greatly appreciated.
  12. hall832

    Hull cleaner

    Re: Hull cleaner Bilge Bully is as close to hands free as you can get. I have drained my bilge completely and dumped two gallons in my bilge and let it sit over night. drained the next day and it was pretty close to spotless. it emulsifies oil and grease
  13. hall832

    Need information on this motor

    Re: Need information on this motor real easy job
  14. hall832

    What is worse than buggering up a screw or bold head?

    Re: What is worse than buggering up a screw or bold head? Or a customer who has neglected his boat to the point i have to fire ax them off
  15. hall832

    I/O vs Outboard?

    Re: I/O vs Outboard? I have heard several different schools of thought on this subject from the old salts. I lean more towards you can get 2-3 years out of your manifold and riser from a owner that stays on top of maintenance and flushing. neglecting your manifolds can lead to serious problems...
  16. hall832

    Need a way to cross over Jabsco to johnson part numbers

    Need a way to cross over Jabsco to johnson part numbers. I have been looking online for a couple days, i can not find a crossover chart.
  17. hall832

    2002 Mercury 40hp 2 Cyl 2 stroke. running ruff at idle

    2002 Mercury 40hp 2 Cyl 2 stroke. running ruff at idle. Idles good for a few seconds and then it coughs. I have cleaned the carb. Idle and high speed are clear. I know i have a fuel issue. What else can cause this idle issue.
  18. hall832

    2001 johnson 2 stroke fuel pump, diagram of inside with diaphragm and springs

    2001 johnson 2 stroke fuel pump, i need a true diagram to see how it is assembled. i have in pieces. any help a diagram of inside with diaphragm and spring
  19. hall832

    2004 Mercury 225 four-stroke EFI no power to Low Pressure fuel pump. Why please help

    2004 Mercury 225 four-stroke EFI no power to Low Pressure fuel pump. Why? 1. I checked the High Pressure Fuel Pump, its coming on with key. 2. I ran 12 volts to the low pressure fuel pump it works. 3. I am getting spark 4. It appears both pumps run off the same relay. but i have no voltage...
  20. hall832

    Help 90 hp Evinrude running hot, new impeller good water flow. not sure poppet vale?

    90hp Evinrude Model # E90ELEUC running hot, new impeller good water flow. not sure if poppet vale? I pulled thermostats and ran with covers off at idle there is hardly any flow. at higher rpms i have great flow. i think i have a poppet valve stuck open. I just cant find it on this motor. Does...
Top