Search results

  1. B

    Installed new/used stern drive now engine died when shifted into forward

    Shifts into reverse without dying, but dies instantly when shifted into forward. No clue about what to do.
  2. B

    1994 350 mag spark plugs, timing recommendations

    Any recommendations on which AC/Delco spark plugs to run on a 94 350 mercruiser, while I'm at it I'd like to set the timing but have no idea where to set it at... any help will be appreciated!!!
  3. B

    Best tune up parts?

    I'm a newby to boats, I want to do an ignition tune up to my 94 Reinel with a 350 mag mercruiser, I believe it has the Thunderbolt ignition. The cap, rotor, plugs, and wires I want to replace for sure but what about the coil? It looks a little rough. The boat takes a bit of cranking to start...
  4. B

    So whats the best boat shop in Utah???

    I need to take my boat to a shop to be tested for water leaks and go through my drive, and I will need the whole bottom of the hull gel coated unless there is extensive fiberglass damage....then it will be totalled out by the insurance. So anyones experience would be great I live in Price but I...
  5. B

    Should I replace the whole lower unit or is there a way to repair this one?

    What should I do? I'm not sure if I need to replace the lower drive, how hard would it be to just swap out the internal parts into another case/shell? The prop is bent a little and I'll send it off to be fixed but I dont know what to so bout the fins that were on the lower drive. could I just...
  6. B

    Slammed boat into rock/sand bar.

    I hit a Sand/rock bar yesterday in my boat and broke the fins off my lower and also scraped the bottom of my boat really bad. The question I have is that when I got the boat up on the trailer and pulled the plug there was a ton of water on the bilge, way more than I have seen before, how do I...
  7. B

    Should I replace the whole lower unit?

    What should I do? I'm not sure if I need to replace the lower drive, how hard would it be to just swap out the internal parts into another case/shell? The prop is bent a little and I'll send it off to be fixed but I dont know what to so bout the fins that were on the lower drive. could I just...
  8. B

    What is your opinion/experience with bearing buddies?

    My trailer has factory grease zerk dust caps but they dont have the springs like the bearing buddies, I have been thinking about installing BB with the springs but I have heard they give you false confidence and that the back bearing can fail because it doesnt get proper lubrication. I'm...
Top