Search results

  1. G

    Power trim

    It’s an old 1990 model motor, here is a picture of the power trim, it bolts to one side of a CMC PT130 jack plate,
  2. G

    Power trim

    I have a power trim question, I have a power trim with a Johnson 40 hp and it works both up and down, it’s full of fluid, no leaks at all, it has been making this loud grinding noise for the last three years, still works but I’m asking if anyone knows what would make this noise the motor, the...
  3. G

    Evinrude 25 Lean sneeze

    I have a 40hp Johnson that did that, here is how to fix it, nothing wrong but need the carbs tuned, take the throttle cable loose, now snap the throttle controll rod loose on the front end, adjust it so it measures 7 and 13/16 inches from center of each socket, loosen the the carburetor lever...
  4. G

    Question on the terrova i-pilot recording a trail?

    just got my Terrova i-pilot mounted, haven't had a chance to put it to use yet, looks like another week. but while reading about recording trails, it says 3 trails, trail A, trail B, and trail C. my question is after recording 3 trails on say Dale Hollow lake, and the next time I go fishing and...
  5. G

    Terrova i-pilot wireing question?

    I had a 12 volt motor guide trolling motor, and bought a 24 volt Minn Kota Terrova i-pilot. I have 2 batteries for trolling and I used a short jumper cable, and connected one end to minus post on battery #1 and the other end was connected to the plus post on battery #2 then connected the red...
  6. G

    Michigan prop #033005 13 and 3/4 x 21 need help with this?

    will a Michigan brand prop with #033005 13 and 3/4 x 21 fit a 2006 mercury 2 cycle 90 hp. and thanks in advance for any info
  7. G

    quicksilver prop question need some info soon

    this guy has a 21 pitch prop for sale, and I need a 21 pitch prop. if this prop will fit my 2006 90 hp mercury 2 cycle motor I will buy it. he don't know if it will fit nor do I. the writing on the prop says, Quicksilver 4811070 A40 21p thanks in advance for any info.
  8. G

    a starter problem, please help

    I took my boat to the lake last weekend, and it ran fine started every time I hit the key. today it had a starter problem. when I turn the key the starter turns but wont stop even when the key is turned off, had to remove the ground cable from solenoid to stop starter. I took the key switch out...
  9. G

    shifting problem

    I need some help, I had to replace my lower unit. and the shifting cables are not right. I put the controller in neutral, and when I turned the shifting rod to find neutral on the lower unit, the shifting rod was all the way back touching the motor block when it went into neutral. it can't go...
Top