Search results

I have 1973 18hp Evinrude motor. It has a 3 blade pin drive prop. I was boating in heavy chop the other day so I was staying close to shore limping the boat back to dock. When I hit a sandbar. the motor got us back after hitting the sand bar but the ride was so choppy i couldn't tell if it...

I had water in my lower unit so I did all the seals and a new impeller and water pump kit. Took her out on the water and it kept jumping out of gear into neutral while accelerating. Everything i had read points to worn gears but I thought they looked good but I also didnt examine every inch...

I have an 18hp evinrude from 1973. I just redid all the seals on the gear case and put a waterpump kit in it. Put it all back together and filled with new gear lube. Dropped her in a barrel and she started second pull. It ran really nice in fwd/neutral/reverse. it stalled out in slow on...

Ok well I found out where the needle bearings were from. the drive shaft bearing in the upper part of the lower unit...:D it's on a 1973 18hp evinrude model 18304A But there is a brass seal and a rubber bushing on top of that bearing. In my manual it says i need a bearing puller special tool...

I was in the process of doing a Impeller change and gear case overhaul when 9 needle bearings feel out of the leg. I am very inexperienced with outboard motors and mechanics in general. So im stuck at this point. From looking through my manual I think these Needle bearings are from the...