Search results

  1. T

    Mounting Depthfinder sending unit in hull

    I have read and installed my sending unit according to instructions on the forum but the sending unit did not stick. The epoxy is still stuck to the hull but the sending unit came unglued. The bottom of the unit is still as shiny and slick as day one. Do I need to sand the bottom of the sending...
  2. T

    4.3 RPM Question

    Rick on another thread you mentioned the following? ?.A WOT RPM that's too low can damage the engine.? I have a 4.3 and very seldom run at WOT. I grit my teeth when I look at the RPMs above 4000. I would never run a car engine at this speed except for passing/ Are these standard blocks from...
  3. T

    2011 4.3 190hp Chevy oil filter

    Can someone help me identify the correct oil filter for this engine? Would also like to have a recommendation on oil weight and brand along with brand of filter. I bought this boat new last year and only have about 30 hours on it. I believe it came with 30 wt in it as the oil pressure acts like...
  4. T

    Steering Adjustments

    I am sure this is the not the correct termology but here goes. My boat pulls to the right when at cruising speed. I have read that you should turn the fin above the prop in the direction the boat is turning. This seems to be opposite of what you would think. Can anyone help me with the correct...
  5. T

    Mounting a transducer on hull

    Has anyone tried to silicone a transducer to the bottom of a boat with success? I hate for pay another $100 for thru hull transducer unless I have to. Thanks, Topcat
  6. T

    Tilt Trim Gage Reading

    I have a new 2011 Mercruser 140 still in breakin mode. When i trim the boat the gage is barely off the bottom of the gage. I would think it should be close to the center of the gage. I don't realy use the gage to determine the correct trim but since it is a new boat i want it to be correct. Any...
Top