Search results

  1. Grizz1288

    Still Running VRO on '98

    I've got a 1998 Johnson J115SLECM on a Flats and Bay 18x8 that has never run better. I rebuilt the VRO when I did all of the carbs last year with the OEM kit and have put at least 20 hours on it since then without issue. I check the oil tank before and after every outing to make sure its...
  2. Grizz1288

    98 Johnson 115 Fuel Prime Flooding

    Just a quick question here. When cold starting this engine I've got about a 50/50 chance of it firing right up or me flooding the motor and I know its 100% operator error. The ignition is a 'push-to-choke' (on this motor there is no choke, it engages the enrichment primer solenoid). My question...
  3. Grizz1288

    On-Board Charger Wiring Diagram / Clarification

    I have installed a new 24V Riptide MK trolling motor on my boat. Along with that comes two brand new size 27 deep cycle batteries that will require charging and maintenance. I also have 2x size 24 marine starting batteries that I would like to charge/maintain at the same time. As I consider this...
  4. Grizz1288

    24V vs 12V Trolling Motor Setup / Weight Distribution

    Good morning, I am installing a new (to me) trolling motor on my 18'8 Flats and Bay and I am contemplating my weight distribution options and was wondering if anyone has gotten into this debate before and what they ended up doing. Situation: I previously had a 12V minn-kota (I forget the model...
  5. Grizz1288

    '98 115 Johnson - Idle Mixture Needle Adjustment ?

    I have had an engine 'sneeze' or cough during very low idle (fully warmed up) and have been trying to trouble shoot. So, I went against everything I have read on the internet and bought a PDF version of the SELOC shop manual for this motor generation. Looking for two things in said manual...
  6. Grizz1288

    '98 Johnson 115 High RPM Bogging

    Re: '98 Johnson 115 High RPM Bogging Just pulled the plugs and they look pretty clean. None of them are wet, but 2/4 are rootbeer on top and slightly black on the bottom, could be running a little rich sometimes. Here is what I pulled out of the fuel water separator. The cup says 16/20...
  7. Grizz1288

    '98 Johnson 115 High RPM Bogging

    I have a 1998 Johnson 115 v4 that has an intermittent bogging issue. The engine starts great from hot and cold. Idles great. Has no issues below 2000 rpms that i can tell. No issues during acceleration to get the boat on plane. While cruising on plane, anywhere between 3000-5000 rpm it will...
Top