Search results

  1. D

    Wiring 2 - 6 volt batteries for fish finder

    Howdy everyone: I would like to wire 2 - 6 volt flashlight batteries to operate my Garmin fish finder. In order to get 12 volts, do I need to attach one end of a lead wire to the + terminal of one battery and then to the - terminal of the second battery? If I am correct, the remaining...
  2. D

    9.9hp Suzuki for a sailboat

    Here's question for you sailboaters: Last year I bought a 9.9hp two stroke Suzuki Hi-thrust motor. The prop is a 10X6. The information I found on the internet claims the motor is used for sailboats and for increased reverse thrust. Can anyone tell me what the motor is/was used for on...
  3. D

    Two speed Minnkota - Paul Douglas

    Hi Paul. Some time ago my nieghbor gave me a Minnkota, two speed motor (no reverse), that developed a whopping 8 lbs. of thrust. It worked great for my small boat. I suppose the one you have may become useless in the future, at which time you can give it to some kid just starting out. Have...
  4. D

    Suzuki 9.9 pee hole

    My motor is a 1996 9.9hp two stroke. I know the pee hole has some debris in it because it dribbles, and after trying to clean it with a small wire it pee's a fairly good stream. However, after a short while it begins to dribble again. There appears to be a small nipple under the cowling...
  5. D

    Going to bass fish Moses Lk. in Washington

    I'm going to fish this lake for the first time. Any advise where to hook into decent size bass? Thanks in advance for your help. DuPont
  6. D

    Suzuki shift adjustment

    I just inspected the water pump impellor on my 1996 two stroke 9.9hp Suzuki and found it to be in great shape. Now that I have all the parts back together, can someone please tell me how to adjust the shift/clutch connector? The two connecting rods are connected by a turn-buckle and lock nut...
  7. D

    Water pump web-site

    Can anyone lead me to a web-site that will give me step-by-step instructions on how to replace the water pump on a 1996 two stroke 9.9hp Suzuki? I've got good mechanical skills but somewhat hesitant to just dive into it. I suppose I could purchase a manual but if a web-site is available, I'd...
  8. D

    Did I make a big mistake with battery water?

    This afternoon I topped off each battery cell with regular tap water. How bad off am I? The battery is relatively new and this is the first time it needed tipping off. The water level in each cell was 1/4 to 1/2 inch low. It's been holding a good charge all winter, with an occasional 1/2...
  9. D

    Axel Seals

    When replaceing the rear axel seal, does the seal get seated against the inner race, or is it seated flush with the axel hub? Any help will be welcome. DuPont
  10. D

    Replacing MinnKota Shafts

    A recent post was inquiring about replacing the shaft on MK motors. In order to do so you must apply heat at the point where the shaft screws into the motor housing. Using a propane torch, carefully heat the area. This will release the bonding agent and will allow you to unscrew the shaft...
  11. D

    Battery maintenance

    I read another post in which a reader stated that leaving the battery charger clamps on the battery will drain the battery - even when the charger is turned off. Is this true??? Not that I'm a know-it-all, but I've never heard of that before. During the winter months my battery is stored in...
  12. D

    Do I need a new thermostat???

    I have a 1996 Suzuki 9.9hp two stroke engine. Just a second or so after starting the engine I get a good flow of water from the water pump port, but the pisser seems somewhat weak, just a strong dribble. No matter how long I run the engine, the amount from the pisser stays the same. Shouldn't...
  13. D

    Transducer causing cavitation? No kidding???

    I read a previous post where the transducer was causing cavitation when turning. If you were to look at the back of my boat, the transducer is mounted on the left. When I make a right turn the motor cavitates. When turning to the left, all is well. The transducer is for a Garmin 160. Can...
  14. D

    Prop size / Pitch

    Howdy everyone. I would be very thankful for some responses to this post. I have a 1996 Suzuki 9.9hp two stroke with the original prop. The motor is in superior condition in all respects. The existing prop has three blades and is 10x6.5. The motor is mounted on a 13ft. fiberglass, dual...
  15. D

    Carb cleaners

    I have seen several products at the local marina that claim to do wonders for the fuel system and carberators. (Cleaning gum, varnish, deposits, etc.) Since the products states that is for outboard motors and such; what are some of your opinions. I don't think this stuff is a substitute for...
  16. D

    Carb cleaners

    I have seen several products at the local marina that claim to do wonders for the fuel system and carberators. (Cleaning gum, varnish, deposits, etc.) Since the products states that is for outboard motors and such; what are some of your opinions. I don't think this stuff is a substitute for...
  17. D

    Spun (or spin) out a prop???

    Howdy everyone. What is meant by the term(s)"to spin out a prop"? I've seen this mentioned in numerous posts and am not sure what people are talking about. Thanks for filling me in. I'm very new to this board and outboards in general. I just recently purchased by first outboard. It's a...
  18. D

    9.9 two stroke slips out of reverse

    Howdy. This is my first post at this site and here is my concern: I just purchased a 1996 Suzuki 9.9 two stroke motor with less than 40 hrs. on the motor and it slips out of reverse when I engage the handle on the side of the motor. Other than that, the motor is in showroom condition and...
Top