Search results

  1. P

    SX-M propshaft carrier set screw

    Anyone have any idea what size & thread pitch the set screw is that secures the carrier on said drive? It's VP p/n 3853272.
  2. P

    Uni-Force dashboard cluster

    Has anybody had any reason too try get ANY kind of older dashboard or single gauge repaired? Older Celebrity. Boat is imacculate with newer motor & wouldn't ya know it, now the tach is acting up! Sheee1tt!
  3. P

    Yamaha NADA guide question

    Why are Yamaha "boats" considered PWC's in thier listings?
  4. P

    Engine stringer bedding

    Got myself involved in replacing the transom wood & now the engine bed in a 1983 Cruisers Inc 22' cuddy. The transom is under control. The question is in regards to the "engine stringers" or engine bed. Do these have to be fastened with epoxy, PL or peanut butter? Or the like. The original wood...
  5. P

    5.0 GL description

    A good friend is buying a 2004 boat powered by VP. The flame arrester cover shows 5.0GL w/SX drive. The seller claims 260 HP. REALLY?:confused: I haven't met the boat yet so I can't give a serial #. I have seen pics & it looks like it's carbed. Any issues that are lurking on this package...
  6. P

    Mercruiser "flat rate" labor schedule

    In particular I'm looking for transom section. Both Alpha & Bravo. As I recall, the shift cable & bellows is not part of the u-joint, exhaust & water hose party. So what I would like to find out is, how much time do they allow for, #1 shift cable & bellows, #2 u-joint, exhaust & water hose on...
  7. P

    115 Yamaha alarm

    I've got a 115 hp Yamaha that runs fine. I keep getting an audio alarm RANDOMLY!!! It's using oil from the tank & both heads are at 135-140 degrees. Any ideas on isolating this issue?
  8. P

    Gear oil capacity

    Does anyone have the gear oil capacity for all Bravo drives?
  9. P

    Info on mid 80's V-6

    I haven't even seen this lovely yet. I have a hunch that is has the prestolite distributor that 2 of the lobes on the point cam are really reaching. I haven't seen 1 for along time. I do seem remember that the points were set in a certain way. May be wrong! But since mother merc made i-boats...
  10. P

    manuals?

    I'm not getting the "link" for service manuals in the STICKY'S. Did something happen with lords above?
  11. P

    Mercury Accessory guide

    Is there any access to the "Mercury Accessory Guide" available here? I've looked in the "sticky's" but didn't find anything. If this gets moved, where will it go?
  12. P

    Proper water hose length on mcm-1

    I'm replacing the water hose on an old inline ser.#3286441. All parts listings I find they say 13 3/4". It seems that I vaguely remember that, that was a type-o & the length should be 12 3/4"! Can I get anyone to agree or even disagree? Thanks
  13. P

    Yamaha V-4 Alarming

    I've got an issue with a 115 V-4 m/n P115TLRT. New water pump. Comp & spark test, good. Strong tell-tail stream, consistent. 2 questions: #1 Would a thermostat on either side cause this? Or #2, the main oil tank, does it have a water sensative sender in it? Runs fine, just has the alarm issue...
  14. P

    MerCruiser TKS (Turn Key Starting) How do owners feel about it?

    I just started this thread because of somebody that had a question in common with an older NON-TKS carb! 2 easy ways to determine if you do have it; #1 From a cold start, simply do nothing but crank the engine. When it starts do nothing but let it warm to temp & your good to go. New boats, this...
  15. P

    gear oil hose

    How long is the hose for the gear oil resevoir? Gimbal to bell housing!
  16. P

    Vibration in a 383 stroker motor?

    Hello. I have an issue with a repower. Started out with a 1989 350 MAG, s/n OC 409667. Let me say that I have been "certified" w/mercury marine since 1983. Among others. Have been put through plenty of obsticles & other "hoop jumping", even had to stand corrected once or twice! LOL The original...
Top