Search results

  1. G

    Water pump impeller blades 1960 Interceptor

  2. G

    Water pump impeller blades 1960 Interceptor

    I’ve got a 1959-1960 interceptor FE block inboard in a century resorter. The water pump uses a fixed bronze hub with two sets of impeller blades, each about an inch and an eighth square, that slide into the hub, and between the sets is a retainer clip. There’s evidence of some gasket-tack type...
  3. G

    Closed Cooling Question

    It seems I'm not getting enough water out of my Alpha drive impeller to cool my engine at mid-range or higher. It's a new pump/impeller kit, and was staying cool around 2700 rpms when I hit the water this spring, but now, especially as the inlet gets covered in marine growth, I'm lucky to run...
  4. G

    Racor on vacuum side of TBI pump

    Looking to add a fuel water separator between my tank and the vac side of a 350 tbi pump. I've got the bracket for the merc. cartridge style, plus the racor spin-on with the solid well on bottom (a replacement filter for the standard merc/sierra stock part). The filter used to be on the carb'd...
  5. G

    Alpha Merc Shift Problems after drive r/r

    I've got an Alpha, 2007 reman unit, on a 1978 housing, mated to a newer 350. Frankenboat, I know... The drive shifted fine when I removed it. To remove it, I put it in forward and unbolted the six nuts. It came off fine. I replaced the impeller and pump housing, replaced the prop zinc, put...
Top