Search results

  1. S

    3.7 coolant weep hole?

    So last summer I replaced cam seals and installed sleeves on the cam, I ran the engine a few times on muffs during the summer wasn't able to use it had no coolant drips. I went to the garage this week to start getting it ready for this season and noticed some coolant at the front of the engine...
  2. S

    3.7l breezeworks alt wires

    just installed electronic ignition and alt. conversion on 1988 3.7l where does the black wire on the alt. go to 3 wire alt and what do i do with the wires that ran to the voltage regulator, thanks scott
  3. S

    help!!! re-installing drive

    so removed drive to replace water impeller kit have it all back together, put drive back on boat can't get it to go in reverse so now drive back on garage floor, so my question is when i put it back together and i have the shift shaft of the drive forward is the prop shaft locked clockwise or...
  4. S

    3.7 timing cover?

    so noticed drop of coolant at weep hole when i was going to do my alt.and electric ignition swap.I started to take the front of the engine apart and i am at the timing cover and it is stuck on tight, have all bolts out but i was looking at the oil pan to cover and is there 3 bolts to it or 5?:blue:
  5. S

    3.7l breezeworks alt conversion with ps question

    Hi there I have an 88 seamaster with a 3.7l with ps and I want to put a breezeworks alt kit on, I know that it is a low mount kit that I need, so I was wondering if someone that has this kit would be able to tell me what the aprox measurement would be from the edge of the crank pulley to the...
  6. S

    Side to side play in alpa1

    I have an 88 alpa1 drive and when I am at the back of the boat I can move the drive a little side to side. I tightened the two bolts at the gimbal ring but still have play, what could be the cause of the play, and what are the fixes? I have the drive off now for the winter to change the impeller.
  7. S

    What hp and what shaft?

    I have a 208 renken seamaster with a 165hp i/o and Cuddy,i am looking at putting an engine bracket on the back and I was wondering what is the smallest hp outboard that would work and what length shaft. The motor is more for my piece of mind getting back in if I have a problem with the I/o when...
  8. S

    looking at grady with 79 omc, yes or stay away?

    Hi i am looking at a 1979 grady white 21' walk around with 5liter that had a repower in 2004 and the drive was rebuilt then also. I know nothing about omc drives and don't know if i should just stay away from it. How are they for reliability,parts and cost of repair? any thoughts and advice...
Top