Search results

  1. L

    carb adj 1997 50 hp

    I have adj screw at 2 1/2 turns out how far can i lean out ? smokes a lot.
  2. L

    1997 force leaking smoke into cowling

    What gaskets do I need to replace? Thanks
  3. L

    1997 50 hp Force

    I have a 1997 force 50 it started to idle bad and not run good at wot. I remove card to clean it look what I found behind the carb. This is part of the dust cover on top of the flywheel. The fome in the top of the cowl. I removed it and cleaned the carb and replaced needle and gaskets runs good...
  4. L

    50 HP Force Carb

    Where can I find a Carb kit for a 1997 50 HP Force?
  5. L

    Will not idle

    Need help 1997 50 hp will not idle. Starts when if push key in runs fuel out then stops. I put new kit in fuel pump this did not help blew jets out with carb cleaner this did not help also replaced plugs. What can I do now.
  6. L

    Old fuel

    I have a 1997 Force 50 hp That has been getting harder to start when cold. I spray fresh fuel in carb it starts up quick. my fuel is from last year. What can i do to this fuel other than dumping it? I have about 5 gal in it.
  7. L

    Voltage Regulator 1997 force 50 hp

    I replaced the voltage reg on my 1997 50 hp force with one from www.powersportparts.net p/n 01-154-16. It cost $28.43 It worked prefect. hope this helps someone.
  8. L

    Warning

    I ordered a voltage regulator/rectifier P/N 01-090-1 from www.mfgsupply.com . This part was defected when i recieved it. This company will not refund or exchange this part. I recomend that you do not order from this company.
  9. L

    1997 50 hp force need help.

    I need help wireing a universal voltage regulator 01-090-1 on my motor. i have read all the post about this. It has two yellow wires and one black and one black with white stripe. If I hook the yellow to my stator the wires get hot and no Dc voltage on eather black wires. Please Help. Larry
  10. L

    50 ELPT1997 Force charging problems

    My voltage went up to about 18 volts while running a FT. normal about 14 volts then droped to 12 volts not charging. I disconected stator wires found about 20 + volts AC . So I reconected stator wires disconected red wire and checked voltage 0 volts Dc. I think voltage reg is bad. I ordered the...
  11. L

    Up date to head gasket help.

    Removed exhaust housing found all gaskets to be in good shape. But after looking real good I found a crack in the water jacket into the exhaust area. I used a Dremel tool to grind out the crack some and clean the area around the crack. and used JB weld to seal crack. I ran the motor for a good...
  12. L

    Head gasket help

    I need help identifing the correct head gasket to order for my Force outboard. s/n oe245971 50 hp ELPT 1997
  13. L

    exhaust gasket

    I have a 1997 force 50 hp that i need to change the exhaust gaskets. Can I do that without removing the power head and do I need to use gasket sealer? Thanks
Top