Search results

  1. A

    Anode and motor trim tab question for 1988 johnson 200

    I have a counter rotating motor used in a single motor application. I bought this engine and it had neither the trim tab fin nor the anode. The C/R trim tab PN 0338743 costs much more than the regular one PN 0333961. Will the cheaper one fit/work since I am using it as a single motor? My...
  2. A

    CDI test procedure question for 1988 johnson 200

    Looking at the CDI electronics test procedure, it provides DVA ranges for the stator and timing base in a connected and unconnected condition. I assume for the disconnected I just separate the wiring harness to test the timing base side. How are you supposed to test in the "connected"...
  3. A

    1988 johnson 200 idle problem

    Motor does not idle well in water in nuetral or in gear. Just a little above all the way to wot it runs fine. At idle, it will run okay for a little then spit/pop run rough and stall. It will crank right back up and do it again. Doesn't matter if cold or warm. I recently took off and cleaned all...
  4. A

    Water squirting from between crankcase and exhaust housing

    I recently purchased a 1988 Johnson 200. It runs fine on hose at any speed or on water once in gear above idle. It is difficult to crank in water and idles rough with regular miss and stall at idle -- usually when trying to dock... Anything above idle it runs great. I noticed that there is...
Top