Search results

  1. W

    honda 4 stroke 20hp 2004

    i have a 4 stroke honda 20hp 2004 when the engine in in neutral and i give it about half revs it starts popping . i have changed the plugs done a oil change also fresh fuel . i have been told there is a rev limiter on this model would this cause a loud popping sound
  2. W

    mariner 60hp 3 cylinder 1988

    the carbs on my engine are knackered they are Wm 16-1-3155 and Wm 16-3 -3347 what i want to know i have just purchased carbs from a 50 or 60 hp engine the carbs are the same type but the codes are different they are WM13-1 AND WM13-3 would they still do ?
  3. W

    mariner 1988 60 hp 3 cylinder 2 stroke

    i have a question about a mariner 1988 60 hp 3 cylinder 2 stroke i have Choke Solenoid and beside it their is a manual pull choke the choke solenoid heats up it cant pull open the choke it has no cables attached to the carb ? it used to click now it does not . i had it of the engine and attached...
  4. W

    mariner 1988 60 hp 3 cylinder 2 stroke

    i have to jump it . very hard to start when it does it runs very uneven and high revs when turning it over sometimes i get a backfire and a puff of smoke . my compression is good fuel ok spark is their but don't know how strong don't have a tester
  5. W

    mariner 1988 60 hp 3 cylinder 2 stroke

    i cant get the engine to fire up .compression good so is spark and fuel is fresh carb full gasket kit . i am jumping the motor and doing the choke by hand . i have unplugged the controller and cable because their is a fault
  6. W

    mariner 60hp 3 cylinder 2 stroke

    i purchased a mariner 60hp a few weeks back . i have done full gasket kit on twin carbs / on fuel pump and changed the fuel filter and renewed water pump the compression on all 3 cylinders are 125 psi and i have good spark .when i put the starter motor back on i went to start it by a jump...
  7. W

    evinrude 1985 75 hp problems

    I have threaded no 1 cylinder the spark plug had taken all the threads with it .i have taken the cylinder head of and also noticed the head gasket was blown also some fine scores on my bores . I only fish in shore so i have taken all the carbon of and just putting a new head gasket back on i...
  8. W

    3 cylinder 1985 evinrude 75

    i got it over a year ago and it was working ok .so this is the first time i started it since i got it . i went to start it today it would turn but not start . i checked the spark plugs they were black and wet .when it was running over a year ago it was very smoky grey in colour because the man...
Top