Search results

  1. Z

    1957 Johnson 18hp help

    How do you increase the tension on the twist tiller, I have to hold the tiller tension, if I release it for a second, it drops down.
  2. Z

    1958 Sea King help

    I have a 1958 Sea King 12 hp, Idles very good, runs at full throttle very good, but at mid range does not run smoothly. Looking for the cause and possible adjustments needed.
  3. Z

    1977 25hp Chrysler Impeller Replacement Question

    Looking to replace the water impeller on a 1977 25hp Chrysler model 252HB. Do you merely remove the 4 bolts to drop the LU to have access to the water pump, or is there a connector bolt to the shift rod. thanks
  4. Z

    1949 Johnson DT-10

    I recently acquired a 5hp 1940 Johnson DT-10. Nice original condition. Has 80lbs compression in each cylinder, is this considered acceptable. Would like to get it running. Does anyone have a parts breakdown they could share. thanks
  5. Z

    1970 Merc 110 Idle Problems

    I have a line on a nice 1970 Merc 110. Motor has good compression, starts and runs but stalls when idling down. What could be the problem. Any help would be appreciated.
  6. Z

    1957 Gale Buccaneer 5hp fuel pump repair kit?

    I have a 1957 Gale Buccaneer 5hp model 5D14B. Looking for the fuel pump repair kit or part number.
  7. Z

    1956 Johnson AD-10 Parts Breakdown

    Anyone out there have the 1956 Johnson AD-10 7.5 hp Parts Breakdown. It would be much appreciated.
  8. Z

    1979 Johnson lower unit compatibility

    I need to replace the lower unit on a 1979 Johnson 70 hp outboard. What years and hp OMC motor lower units are compatible. Any info would be much appreciated.
  9. Z

    1997 Mercury 40hp 4cyl spark loss

    I am running a 1997 Mercury 40hp 4cy. I suddenly lost spark on all cyl, what electrical component may have caused the failure.
  10. Z

    1997 Mercury 40 hp loss of power problem

    While running my pontoon yesterday I encountered a loss of power problem. I was running at full throttle and suddenly had a loss of power, it slowly picked up speed and ran normal for a couple of minutes and then started to lose power again. RPM's drop from 5200 to 3000 and then pick up again...
  11. Z

    1954 Johnson RD-16 Parts List

    Can anyone help me out with the parts breakdown for a 1954 Johnson RD-16. It would be much appreciated.
  12. Z

    Mercury KF7 rebuild question

    I have a Merc KF7 I am planning on rebuilding, I have the opportunity to get a KG7 powerhead, will I be able to replace the KF powerhead with the KG powerhead without any modifications and get the uprade in hp and perfomance. Will the tank and lower cowl fit. I understand I will need a KG carb...
  13. Z

    Scott Atwater 1-16 5hp question

    How common is the Scott Atwater 5hp model 1-16? I found one that is complete and better than average cond, decals and labels in tact. Has spark, compression and shifts, tank is clean. The casting at the top of the head is cracked that attaches the tank. Does $60 sound like a buy?
  14. Z

    Mercury KF-7 info needed

    I recently acquired a Mercury KF-7 Super 10, original and complete, need restoration. Anyone have the parts breakdown, I would sure appreciate it. Also where can I get a good shop manual.
  15. Z

    1956 Johnson 15hp carb. adjustment question

    In the Cylmer "Old Outboard Motor" manual they state that for the 1956-68 Johnson/Evinrude 12-20hp, "normal initial setting for both the high speed mixture adjusting needle and the low speed adjusting needle is 3/4 turn from closed position." Does this sound correct?
  16. Z

    1956 Johnson 15hp. upper side mount installation

    On a 56 Johnson 15hp what is the procedure to install a upper side mount, is there an easy way without a teardown.
  17. Z

    1956 Johnson 15hp lower unit eye hook attachment.

    I picked up a 1956 Johnson 15hp that has some kind of eye hook achment, it appears to be made as a after market part or by OMC for for this particular lower unit. Anybody know anything about it and what it was used for.
  18. Z

    1956 Johnson 15hp question

    I came across a 15hp Johnson FD-10, it is in nice original cond. I can probably get it for $100. The owner stated that he was using chain saw oil in it rather than outboard oil and the motor was giving him starting trouble. My question is might this engine be toast. What internal damage may have...
  19. Z

    1951 Sea King 5hp Questions

    I recently picked up a 1951 Sea King 5hp model 15GG-9015. I'm restoring it as a way to cure my cabin fever. What is the procedure to replace the water impeller, does the powerhead have to be removed to drop the driveshaft. Also where might I get a parts breakdown for this motor. Any info would...
  20. Z

    1963 johnson model# rx-11a 28 hp question

    Is the 1963 Johnson Super Seahorse 28 hp. model# rx-11a an electric shift model?
Top