Search results

  1. A

    Lowrance LMS-332c Power switch issue / screen flashes - Repair help

    Here's my LMS 332c circuit board. I'm showing where the power source is on the lower right, and where I believe the first two ribbon cables that lead to the power switch on the front panel (upper left) are. Can anyone tell me how to disable the internal power switch and where? I want to install...
  2. A

    82 Merc 80hp Shift Shaft Alignment problem

    I've followed instructions in the manuals which indicates to install lower unit with gear housing in Neutral and I've made sure the lower unit is in Neutral but when I tighten up the bolts the upper shift shaft is pushed upward. Manual says to re-align shafts with light hammer taps using punch...
  3. A

    1983 80hp Merc hesitates & dies after warmed up

    Seems to run great until after about 10minutes being warmed up. It starts to hesitate when you put the throttle down and progressively gets worse. I replaced all fuel lines. Replace fuel pump gaskets, replaced one float that had one side full of fuel so thought that was it. Seemed to run...
  4. A

    1975 50hp Evinrude - water in cylinder?

    My engine starts and runs but does not idle very well. Will die often when putting in forward and especially reverse. Once up to speed seems to run well. When I take lower spark plug out there always appears to be water droplets on the plug or condensation if you will. I've replaced Head...
  5. A

    1975 50hp Evinrude bolt Torque specs?

    Anyone happen to have the bolt torque specs for the following on my 1975 50hp Evinrude? Head Bolts Exhaust Cover Bolts Exhaust Housing Bolts Replacing all gaskets to try and finally fix a problem I've had with water in the cylinders.. I know I should purchase a manual but planning to sell...
  6. A

    1975 50hp Evinrude, can't remove powerhead/exhaust housing

    I have a 1975 50hp Evinrude Model# 50573b. I can't remove the powerhead or may also be called "exhaust housing". It's part #56 on this link: http://www.boats.net/parts/search/BRP/EVINRUDE/1975/50573B%201975/EXHAUST%20HOUSING/parts.html# I've removed the engine block with powerhead from lower...
Top