The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
There are Multiple kill switches on most 2 stroke outboards. Among them are; to keep you from starting the motor when it is not in its lowered position and not in neutral and not at idle. then there are ones for runaway and for when you want to turn it off. Most of these conditions ground your...
Try looking through the parts list on this web site. find the silencer. where does it mount? mine (older motor) has an aluminum disk with three machine screws that mounts on the lower engine cover Under the carburetor. Its purpose is to cushion the air coming into the cover, not filter it...
That is off the "T" handle. It's an extension of the handle to center on recoil back into the cover, and they sometimes break off and get jammed in the pulley. As for starters recoil and electric, as long as your flywheel has a ring gear, starters from 18hp to 35hp and their brackets should...
64' 18hp fastwin Impeller doesn't pump water after replacement & other circumstances
I need to know if the impeller can be checked by removing the thermostat, Before I pull the thing all apart again.
I borrowed a 64' 18hp fastwin from my cousin that wasn't running. He had it in saltwater last...
I took my boat out Thursday. It started right up. The 28hp seemed weak, I couldn't seem to get it to plane. I tried adjusting the carb, and the tilt. It would dig in, but not pull out of its hole. I spent two hours on the lake, just happy to be there. I did put the steering cable on wrong, so...
I have an old automotive tach with settings for 4/6/8 cylinders. It has two leads, one for ground and one for the positive side of the coil. I have the positive side connected to one of my coil wires at the cut out switch and the other grounded. I have set it to 4 cyl and it works, kind of...
Yeah! It worked!!!
The 40352d (63' 40hp Evinrude Big twin) with a bad piston became a parts motor for my RXL10C (62' 28hp Johnson Long shaft.)
The part no for the shift rod was the same for both short versions of each but the drive shafts had different numbers.
I had hoped I could just swap...
I trying to revive a 63' Big Twin 40hp 40352d That's getting spark to only one cylinder.
http://i1024.photobucket.com/albums/y309/tootallofwa/engineIDsm.jpg
My first thought was that I need to check coils, points, plug wires which I haven't done yet...
