Search results

  1. N

    Trim Tilt motor Yamaha 80 hp 1984 AETO

    I took the power head off this about a year ago to rebuild it and everything else was working ok. I have now put the power head back on and I can not get the trim tilt to work. I have taken the main motor cables off the Relays ( 2 of them, Relays that is) 1 blue and 1 green and then theres a...
  2. N

    Yamaha 80 powerhead bolts stuck

    I took the powerhead off about 1 yr ago, and at the time new the bolts where only just moving with out snapping. Today I have been trying to get them out ,but I cant get them out. Some of them move ok but wont pull out but 2 are only moving very slightly (when i hit them with a big hammer)...
  3. N

    Set STATOR on fire

    On my 80 AETO outboard whilst do repairs to the block the heat mates i had in place caught fire :eek: These also melted the wire casing to the stator and some of it looks a bit black.I have read a few post about repairs to the stator(rewired) but apart from the melting of wires would there be...
  4. N

    Block repair 80 AETO 1983

    I need to repair the block . I am hoping to use HTC 2000 . The block is warn on the outside of the water way in 2 areas on the side that the cylinder head attaches to. and a small 2ml deep grove on the exhaust side of the block,this is going from the exhaust to water way.Would a filler do the...
  5. N

    80 hp AETO 1986 2 stroke over heating

    I have a 1986 80hp AETO. The problems are as follows: When the engine is running on a water flush it seems ok, but as soon as it is put in the sea and under load the buzzer goes of :eek: I put this down to over heating so change the water impeller but still the same problems. I also added oil...
Top