Search results

  1. O

    upping hp 200 - 250 will it fit???

    I have a 93 yammie 200 hp and can get a deal on a 96 250hp powerhead as mine snapped a crank a while ago. Will the 250 drop in and would I have to change the carbs??
  2. O

    removeing sticker adhesive???(found the answer in boat ??)

    I'm trying to get the emblem adhesive off my yamaha cowling. I have tryed several liquids and a scotch brite wheel and it just moves it around. The heat gun didn't do much good either and I don't want to blast it off. Any suggestions???????? :confused: I tryed the search and it keeps...
  3. O

    200 yamaha crank

    anyone know where I can pickup a crank for a 93 yamaha 200???
  4. O

    can the reeds be flipped

    93 200hp yammy 200txrr. I have 3 reeds that do not contacat the reed base, can I turn them around?? also will those reeds that do not make contact make an engine miss at wot and make some ugly noise in the power head at low idle?? :confused:
  5. O

    good gasket sealer???

    what do you guy's use as a good sealer to go between the intake to the reed valve plate to the crankcase???
  6. O

    pine island fl.

    anyone know the # for richards mobile marine in pine island or frt meyers, I lost the one I had and directory assistance can't find it
  7. O

    Yamaha experts, tackle this one?????

    I have a 93 yamaha 200 model 200TXRR and it started making a real nasty rattle from the power head at idle. It seems to run fine at 3000-3700, anything over that and it starts to missfire, I'm thinking a loose conecting rod end, any tests I can do to eliminate the obvious??? :( :(
  8. O

    no spark on 2 hp johnson

    87 2 hp johnson. Not getting any spark at plug. I have continuity through the plug electrode and over 500 volts at the end of the plug wire, now, how many volts should I get and does it have to be in the water so it can ground so I can get a spark. I can't get spark from the plug wire either...
  9. O

    Great bay in N.H.??

    anyone been fishing in great bay N.H. or Jeffries ledge??
  10. O

    decarb, when and how often????

    I have an 93 200 hp yamaha that has 100 hours on a total rebuild top to bottom and need to know when and how often should I decarb. What is a good product to use??
  11. O

    high pitched buzz from engine alarm

    I have a 93 200hp Yamaha and if I turn on any switch with the engine on or off like for the bilges, lites, electronics etc. I can hear a high pitched buzz from the engine alarm, it's barely audibal but annoying as hell, it never did this before any ideas on what causes it and how to fix it. I...
  12. O

    useing bondo

    is it safe to use bondo on f/g?? i have a wear spot about 6"x3" from rubbing on a nail or something and need to fill it in.
  13. O

    bouyancy = flotation???

    what is the rec :confused: ipe for 1lb of bouyancy will hold up how much weight?????
  14. O

    mooring weight???

    anyone know how to figure how much a mooring should weigh to hold down a 25' wellcraft coastal in a tidal river?? Is there a formula I can use??
  15. O

    side vent handles

    anyone know where I can find side vent handle?latches for my wellcraft cuddy?? :)
Top