Search results

  1. C

    Fluid leaking behind prop (pic inside)

    What is the deal? Is there a seal that needs to be replaced?
  2. C

    96' 130 rude' trim problems

    My original trim motor had rusted through and would get stuck when left for more than a day or so. I ordered and installed a new trim motor and I am having new problems from it. Once installed, the trim motor seemed to "O.K." for one cycle up and down. It was sluggish but it did go. I lifted it...
  3. C

    Idle adjust, 96 130 rude'

    E130TLEDM My engine is running great on the muffs but idles a bit to low in the water. What is the proper means of adjusting the idle on this motor? Should I adjust the throttle linkage or the low speed jets which are currently set at the factory recommended 3.5 turns out? Thanks, Curt
  4. C

    Transom bracket on an 18' boat?

    I have a 1986 18' Wellcraft Fisherman that I frequently venture offshore in. I love the benefits of a closed transom. Is an 18' boat too small for a Transom bracket?
  5. C

    Evinrude starter problem

    96' E130TLDEM The starter does not engage the flywheel on every occasion. I am assuming that the drive assembly is damaged as I see no wear on the gear protruding from the starter. Is it probable that the drive gear is the damaged component and if so do I need to order the complete assembly...
  6. C

    Evinrude 130 horse problem

    I have a 96 Evinrude 130hp. The motor fires right up but has a problem accelerating ONLY when in gear and in the water. The last time I took the boat out I had to give it neutral throttle for a while (long enough to warm up) before it would run when in gear. After it had warmed up it would run...
Top