Search results

  1. T

    1994 yamaha 200hp V6 carburator

    could any one help me on carb settings on a 1994 yamaha 200hp V6. I would like to know if the high and low jets are fixed jets if not does anyone know there settings and what is the pilot settings are for the air fuel mixture. Any help will be appreciated.
  2. T

    Sensor coil ohm readings

    Hello all. I am suspecting my sensor coil is playing up on a 1990 evinrude 90hp V4. took the plug apart and tested the 5 needles which all but one gave a reading of 15 OHMs (believe it should be around 40OHMs). This seems a little low to me, IS IT???? and if so what should it be? If it is too...
  3. T

    Stator ohm readings

    Hello all. I am suspecting my stator is playing up on a 1990 evinrude 90hp V4. took the plug apart and tested the 5 needles which all but one gave a reading of 15 OHMs. This seems a little low to me, IS IT???? and if so what should it be? If it is too low i take its a new one? Would the...
  4. T

    Evinrude 1990 90hp V4 on VRO running problems

    Hello to all. My evinrude 90hp will run fine on muffs but not in the water. Idle is fine and will throttle up out of gear fine, but as soon as i put it in gear it becomes a little lumpy when i try to open the throttle it wants to stall and have to take it up slowly. I took the prop off (to see...
  5. T

    rough idle and dies in gear

    hello every one. I have a 1990 evinrude 90hp V4 that idles rough then dies and when put into gear dies. The engine did start at high revs approx a week ago and have had this problem since. The engine will start on high revs but when put to idle after warm it will run for a little while cough...
  6. T

    lumpy in gear

    hello to all. I have a 1990 evinrude 90hp V4 that is running a little rough at idle but when i put it into gear it becomes very lumpy and does so at all revs. its that lumpy it vibrates the boat. I have changed the plugs and leads and checked the spark and seems OK, cleaned the carbs, checked...
Top