Search results

  1. G

    OMC Carb to injection

    Is there such a kit to change a four barrel quadrajunk to a fuel injection system. I've looked around a little bit online, I can't seem to find one. It's for an 88 OMC 5.7. The carb is on an edelbrock manifold and doesn't seem to look like it's the proper fit... Instead of spending a thousand...
  2. G

    Timeing marks,harmonic balancer

    O.k... I have a 1988, OMC 5.7L. I went to set the timing and there is no gauge. Not only that, but, my manual shows the #1 cylinder to be at 3:00 on the distributor in their drawing. The #1 wire is at 6:00 on the motor. Now, where the guage should be, the line on the harmonic balancer is no...
  3. G

    Trim sending unit

    I have a 1988 OMC 5.7L. The trim gauge has not worked since I got the boat earlier this year. I looked at the sending unit to adjust it, and, there is no adjusting it... Now..., the arm on the sending unit doesn't even touch the drive housing at all. I'm sure the previous owner just through...
  4. G

    Gauges flicker

    O.k... On a 1988 Donzi, OMC 350, 5.7L. When the motor is running all my guages flicker... I mean, they register, and show close to where they're supposed to be, but, the flicker back and forth a hair. Like the voltage meter hits around 14, and jumps quickly back and forth from 12... The oil...
  5. G

    Taking on water

    O.k... I just bought my first bought, a fixer upper. The drain plug leaked bad. I replaced it with a new one. Took the boat out over the weekend and had it sit in the water for several hours. No leaking... I then took the boat out around the lake a couple of times... I ended up with a little...
  6. G

    Taking on water

    O.k... I just bought my first bought, a fixer upper. The drain plug leaked bad. I replaced it with a new one. Took the boat out over the weekend and had it sit in the water for several hours. No leaking... I then took the boat out around the lake a couple of times... I ended up with a little...
Top