Search results

  1. C

    ok now I'm confused! stupid fiberglass!!

    after reading too many threads on fiberglass, i am getting more confused the more i read..ok so now my question...why can you put epoxy over poly, but not poly over epoxy? it would seem to me that either way it is still poly against epoxy.....now this is assuming the base layer has fully cured...
  2. C

    what are the pros/cons of flat bottom boats

    i have been looking at boat plans for a future project, and have narrowed down my search to two boats. both are identical except one is v botton, other is flat bottom. the boat is a 19 foot cabin dory from beteau. i think that the flat bottom would be my choice for 2 reasons..ease of build, and...
  3. C

    1971 glastron v164 rebuild...attempt#1

    ok folks here goes my attempt at a boat rebuild. i will start by saying i couldnt even begin a project like this without iboats and all the very helpfull members, so in advance i say thank you:) no on with the basics...the boat is a 1971 glastron v164, has volvo aq130c 4 cyl, 250 outdrive, and...
  4. C

    fiberglass terms-need explanations

    hello all i am still new here, just getting the hang of these forums, so bear with me here...anyways, after many late nights reading about transom replacement, i have a few questions as i will be doing this soon.. 1) what is the purpose of using fiberglass mat between the sheets of ply? 2)...
  5. C

    how fast should this boat go

    i am in the process of repairing a 1971 glastron v164 with aq130c engine, 250 outdrive and 14x19 prop. i was just wondering about what to expect as far as speed assuming the boat isnt overloaded, engine at optimum performance, etc etc thanks for any info
  6. C

    rebuilding volvo aq130c

    how much can a block be bored oversized. my engine is 1971, has already been bored 20 over, and now has hole in rear piston. dont know yet if it needs reboring, just got motor out today and torn down. the cam appears to have a flat spot on one of the lobes. Can i use auto cam, or do i need...
Top